Acer K10 manual Using electrical power

Page 4

iv

the product.

To avoid damage of internal components and to prevent battery leakage, do not place the product on a vibrating surface.

Never use it under sporting, exercising, or any vibrating environment which will probably cause unexpected short current or damage rotor devices, lamp.

Using electrical power

This product should be operated from the type of power indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company.

Do not allow anything to rest on the power cord. Do not locate this product where people will walk on the cord.

If an extension cord is used with this product, make sure that the total ampere rating of the equipment plugged into the extension cord does not exceed the extension cord ampere rating. Also, make sure that the total rating of all products plugged into the wall outlet does not exceed the fuse rating.

Do not overload a power outlet, strip or receptacle by plugging in too many devices. The overall system load must not exceed 80% of the branch circuit rating. If power strips are used, the load should not exceed 80% of the power strip's input rating.

This product's power cord is equipped with a three-wire grounded plug. The plug only fits in a grounded power outlet. Make sure the power outlet is properly grounded before inserting the power cord plug. Do not insert the plug into a non-grounded power outlet. Contact your electrician for details.

Warning! The grounding pin is a safety feature. Using a power outlet that is not properly grounded may result in electric shock and/or injury.

Note: The grounding pin also provides good protection from unexpected noise produced by other nearby electrical devices that may interfere with the performance of this product.

Use the product only with the supplied power supply cord set.

Image 4
Contents Acer Projector K10 Users Guide Page Information for your safety and comfort Turning the product off before cleaningUsing electrical power Additional safety information Product servicingOperating environment for using wireless optional Medical devicesVehicles Potentially explosive environmentsHearing Protection Disposal instructionsPrecautions Usage NotesPage Contents Page Product Features IntroductionContents Projector Overview Projector OutlookFront / upper side Rear sideControl Panel Function DescriptionConnecting the Projector Getting StartedTurning the Projector On/Off Turning On the ProjectorTurning Off the Projector Projector Overheated. Lamp will automatically turn off soonTo raise the image Adjusting the Height of Projected ImageTo lower the image How to Optimize Image Size and Distance Figure Fixed distance with optimal screen sizeImage cm Using the OSD menus Onscreen Display OSD MenusColor Setting Display ModeImage Setting TintEnglish Management Setting Language SettingTroubleshooting Image Problems and SolutionsEnglish Problems with the Projector OSD MessagesLED & Alarm Definition Listing LED MessagesSpecifications Ntsc M/4.43, PAL B/D/G/H/I/M/N, SECAM, HdtvCompatibility Modes VGA AnalogVGA Analog Hdtv Signal FCC Notice Operation conditionsRemarque à lintention des utilisateurs canadiens Declaration of Conformity for EU countriesEuropean Union EU List of applicable countriesFederal Communications Commission Declaration of Conformity Declaration of Conformity