Ampro Corporation 420 quick start 1st Turn Clockwise 2nd Turn Counter- Clockwise

Chapter 2 Installing CoreModule 420 Options

1st Turn Clockwise

2nd Turn Counter- Clockwise

CM420QkS_07a

Figure 2-5. Removing the CompactFlash Card

6.Turn the screwdriver clockwise to loosen the CompactFlash card as shown in Figure 2-5.

7.Move the screwdriver to the other slot and turn the screwdriver counter-clockwise to completely disengage the CompactFlash card from the socket. See Figure 2-5.

8.Grasp the two sides of the CompactFlash card and gently pull it from the CompactFlash socket/protective cover and place on anti-static surface or in anti-static bag.

9.If you are installing a new or the same CompactFlash card, skip to the Installing the CompactFlash Card procedure.

10.If your are not re-installing a new or the same CompactFlash card continue with this procedure.

11.Turn the CoreModule 420 back over onto the bottom of the board, placing it on the work surface.

12.Reconnect any cables you disconnected earlier to turn the board over.

13.Ensure all other connections to the CoreModule 420 are still well connected.

14.Plug the power supply’s power cord into the AC power source and restore power.

CoreModule 420 QuickStart Guide 17