Acer X1230S manual Security, Timeout Min, User Password

Page 34

English

22

Security

This projector provides a useful security function for the administrator to manage the usage of the projector.

Security

Press

to change the "Security" setting. If the security

function is enabled, your must enter "Administrator Password" first before changing the security setting.

Select "On" to enable the security function. You have to enter password depending on the "Security Mode". Please refer to "User Password" section for details.

If "Off" is selected, you can switch on the projector without password.

Timeout (Min.)

Once "Security" is set to "On", you can set timeout function.

Press to select timeout duration.

The range is from 10 to 990 minutes.

When time is up, the projector will request you to enter the password again.

The factory default setting of "Timeout (Min.)" is "Off".

Once the security function is enabled, the projector will request you to enter password when switching on the projector. Both "User Password" and "Administrator Password" can be accepted for this dialogue.

User Password

Press to set up or change "User Password".

Use the numerical keys on the remote control to set the password and press "MENU" to confirm.

To delete the digits, Press .

Enter the password again when you see "Confirm Password" displayed.

The password should be 4~8 digits in length.

If you select "Request password only after plugging power cord", you are requested to input the password every time the power cord is plugged.

If you select "Always request password while projector turns on", you are requested to input the password every time the projector is turned on.

Image 34
Contents Acer Projector X1130/X1230/X1230S Series Users Guide Page Information for Your Safety and Comfort Turning the product off before cleaningUsing electrical power Additional safety information Product servicingPage Operating environment for using wireless function Optional Medical devicesVehicles Potentially explosive environmentsDisposal instructions Mercury advisory Precautions Usage NotesContents Regulations and safety notices Product Features IntroductionPackage Overview Projector Outlook Projector OverviewDescription Control Panel Function DescriptionRemote Control Layout VGAFreeze Connecting the Projector Getting StartedTurning the Projector On/Off Turning On the ProjectorProjector Overheated. Lamp will automatically turn off soon Turning Off the ProjectorFan fail. Lamp will automatically turn off soon Adjusting the Projected Image Adjusting the Height of Projected ImageHow to Optimize Image Size and Distance 164 Desired Image Size Distance m Top cm Diagonal inch Desired Image size Installation Menu User ControlsAcer Empowering Technology Empowering KeyUsing the OSD menus Onscreen Display OSD MenusColor Image Ratio Rear-CeilingAspect Auto KeystoneMenu Location SettingClosed Caption Enable Source LockUser Password Timeout MinSecurity ECO Mode Administrator PasswordReset ManagementAudio Timer LanguageTroubleshooting AppendicesEnglish Problems with the Projector OSD Messages LED & Alarm Definition Listing LED MessagesReplacing the Lamp Ceiling Mount Installation Attach the ceiling bracket to the ceiling rod Adjust the angle and positioning as necessary Specifications Below items are for X1230/X1230S only VGA Analog PC Signal Compatibility ModesYPbPr Signal Secam FCC notice Operation conditionsDeclaration of Conformity for EU countries Remarque à lintention des utilisateurs canadiensRadio device regulatory notice General List of applicable countries Article 3.1a Health and SafetyEuropean Union EU Article 3.1b EMCFederal Communications Commission Declaration of Conformity Article 3.2 Spectrum Usages -. EN300 328