Acer X1230S manual Product servicing, Additional safety information

Page 5

v

Product servicing

Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to qualified service personnel.

Unplug this product from the wall outlet and refer servicing to qualified service personnel when:

the power cord or plug is damaged, cut or frayed

liquid was spilled into the product

the product was exposed to rain or water

the product has been dropped or the case has been damaged

the product exhibits a distinct change in performance, indicating a need for service

the product does not operate normally after following the operating instructions

Note: Adjust only those controls that are covered by the operating instructions, since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal condition.

Warning! For safety reasons, do not use non-compliant parts when adding or changing components. Consult your reseller for purchase options.

Your device and its enhancements may contain small parts. Keep them out of the reach of small children.

Additional safety information

Do not look into the projector's lens when the lamp is on. The bright light may hurt your eyes.

Turn on the projector first and then signal sources

Do not place the product in following environments:

Space that is poorly ventilated or confined. At least 50cm clearance from walls and free flow of air around the projector is necessary.

Locations where temperatures may become excessively high, such as inside of a car with all windows rolled up.

Locations where excessive humidity, dust, or cigarette smoke may contaminate optical components, shortening the life span and darkening the image.

Locations near fire alarms.

Locations with an ambient temperature above 40 ºC/104 ºF.

Locations where the altitudes are higher than 10000 feet.

Unplug immediately if there is something wrong with your projector. Do not operate if smoke, strange noise or odor comes out of your projector. It

Image 5
Contents Acer Projector X1130/X1230/X1230S Series Users Guide Page Turning the product off before cleaning Information for Your Safety and ComfortUsing electrical power Product servicing Additional safety informationPage Medical devices Operating environment for using wireless function OptionalPotentially explosive environments VehiclesDisposal instructions Mercury advisory Usage Notes PrecautionsContents Regulations and safety notices Introduction Product FeaturesPackage Overview Description Projector OverviewProjector Outlook Function Description Control PanelVGA Remote Control LayoutFreeze Getting Started Connecting the ProjectorTurning On the Projector Turning the Projector On/OffFan fail. Lamp will automatically turn off soon Turning Off the ProjectorProjector Overheated. Lamp will automatically turn off soon Adjusting the Height of Projected Image Adjusting the Projected ImageHow to Optimize Image Size and Distance 164 Desired Image Size Distance m Top cm Diagonal inch Desired Image size User Controls Installation MenuEmpowering Key Acer Empowering TechnologyOnscreen Display OSD Menus Using the OSD menusColor Image Aspect Rear-CeilingRatio Auto KeystoneClosed Caption Enable SettingMenu Location Source LockSecurity Timeout MinUser Password Reset Administrator PasswordECO Mode ManagementAudio Language TimerAppendices TroubleshootingEnglish Problems with the Projector OSD Messages LED Messages LED & Alarm Definition ListingReplacing the Lamp Ceiling Mount Installation Attach the ceiling bracket to the ceiling rod Adjust the angle and positioning as necessary Specifications Below items are for X1230/X1230S only Compatibility Modes VGA Analog PC SignalYPbPr Signal Secam Operation conditions FCC noticeRadio device regulatory notice General Remarque à lintention des utilisateurs canadiensDeclaration of Conformity for EU countries European Union EU Article 3.1a Health and SafetyList of applicable countries Article 3.1b EMCFederal Communications Commission Declaration of Conformity Article 3.2 Spectrum Usages -. EN300 328