Onkyo HT-R490 appendix Specifications, Amplifier Section Tuner Section, Video Section, General

Page 36

Specifications

AMPLIFIER SECTION

 

TUNER SECTION

 

Continuous Average Power output (FTC)

FM

 

All channels:

55 watts per channel min. RMS at 8 ohms,

Tuning Range:

87.5-108.0 MHz (50 kHz steps)

 

2 channels driven from 20 Hz to 20 kHz

Usable Sensitivity

 

 

with no more than 0.08% total harmonic

Mono:

11.2 dBf, 1.0 µV (75 ohms)

 

distortion.

Stereo:

17.2 dBf, 2.0 µV (75 ohms)

 

70 watts min. RMS at 6 ohms, 2 channels

50 dB Quieting Sensitivity

 

 

driven from 1 kHz with no more than

Mono:

17.2 dBf, 2.0 µV (75 ohms)

 

0.1% total harmonic distortion.

Stereo:

37.2 dBf, 2.0 µV (75 ohms)

Continuous Power output (DIN)

75 watts 5 at 6 ohms

Capture Ratio:

2.0 dB

Maximum Power output (EIAJ)

100 watts 5 at 6 ohms

Image Rejection Ratio:

40 dB

Total Harmonic Distortion:

0.08% at rated power (Front)

IF Rejection Ratio:

90 dB

IM Distortion:

0.08% at rated power (Front)

Signal-to-Noise Ratio

 

Damping Factor:

60 at 8 ohms (Front)

Mono:

76 dB

Input Sensitivity and Impedance

 

Stereo:

70 dB

LINE (CD, TAPE, DVD, VIDEO 1, 2): 200 mV, 50 kohms

Alternate Channel Attenuation:

55 dB

MULTICHANNEL INPUT

 

Selectivity:

50 dB (DIN)

(FRONT L/R, SURROUND L/R,

 

AM Suppression Ratio:

50 dB

CENTER):

200 mV, 50 kohms

Total Harmonic Distortion

 

(SUBWOOFER):

36 mV, 50 kohms

Mono:

0.2%

DIGITAL 2 (COAXIAL):

0.5 Vp-p, 75 ohms

Stereo:

0.3%

Output Level and Impedance

 

Frequency Response:

30 Hz-15 kHz, ±1.0 dB

Rec out (TAPE, VIDEO 2):

200 mV, 2.2 kohms

Stereo Separation:

45 dB at 1 kHz

Pre out (SUBWOOFER):

1 V, 2.2 kohms

 

30 dB at 100 Hz-10 kHz

Frequency Response:

20 Hz to 100 kHz, +1/–3 dB

AM

 

RIAA Deviation:

20 Hz to 20 kHz, ±0.8 dB

Tuning Range:

530-1,710 kHz (10 kHz steps)

Tone Control

 

Usable Sensitivity:

30 µV

Bass:

±10 dB at 50 Hz

Image Rejection Ratio:

40 dB

Treble:

±10 dB at 10 kHz

IF Rejection Ratio:

40 dB

Signal-to-Noise Ratio

 

Signal-to-Noise Ratio:

40 dB

CD/Tape:

100 dB (IHF-A)

Total Harmonic Distortion:

0.7%

VIDEO SECTION

Input Sensitivity and Impedance

VIDEO (DVD, VIDEO 1, 2): 1 Vp-p, 75 ohms

S VIDEO (DVD, VIDEO 1): 1 Vp-p, 75 ohms (Y) 0.28 Vp-p, 75 ohms (C)

Output Level and Impedance

VIDEO (VIDEO 2, MONITOR):1 Vp-p, 75 ohms

S VIDEO (MONITOR): 1 Vp-p, 75 ohms (Y) 0.28 Vp-p, 75 ohms (C)

GENERAL

Power Supply:

AC 120 V, 60 Hz

Power Consumption:

3.4 A

Dimensions (W H D):

435 150 339 mm

 

17-1/8” 5-7/8” 13-3/8”

Weight:

9.7 kg, 21.4 lbs.

REMOTE CONTROL

Transmitter:

Infrared

Signal range:

Approx. 5 meters, 16 ft.

Power supply:

Two “AA” batteries (1.5 V 2)

Specifications and features are subject to change without notice.

Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN

Tel: 072-831-8111 Fax: 072-833-5222

ONKYO U.S.A. CORPORATION

18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.

Tel: 201-785-2600 Fax: 201-785-2650 E-mail: onkyo@onkyousa.com

ONKYO EUROPE ELECTRONICS GmbH

Industriestrasse 20, 82110 Germering, GERMANY

Tel: 089-849-320 Fax: 089-849-3265 E-mail: info@onkyo.de

ONKYO CHINA LIMITED

 

 

 

 

 

Units 2102-2107, Metroplaza Tower I, 223 Hing Fong Road, Kwai Chung,

HOMEPAGE

N.T., HONG KONG Tel: 852-2429-3118 Fax: 852-2428-9039

http://www.onkyo.co.jp/

 

 

 

 

SN 29343046

W0103-1

 

E

 

 

 

 

Image 36
Contents HT-R490 Important Safeguards AvisPrecautions Features Supplied accessoriesBefore using this unit Using the remote controllerFront panel facilities # $Front panel facilities = Remote control sensor SW Mode button# FM Mode button Tuning /£ buttonsRemote controller Rear panel facilities Remote Control Rear panel facilitiesDigital Input OPTICAL/COAXIAL Multi Channel InputExample of how to connect your equipment Example of how to connect your equipment Connecting your audio components Connecting a CD playerConnecting a video cassette recorder Connecting a satellite tuner or televisionConnecting a television monitor or projector DVD Speaker placement Important points regarding speaker placementPositioning speakers Standard speaker system for reproducing surround soundConnecting speakers Connecting antennas Fully insert the stripped end of the cordExtend the antenna cord Connecting antennas Connecting an AM outdoor antennaConnecting an FM outdoor antenna Directional linkageConnecting the power Connecting the powerTurning the power on from the remote controller Press the STANDBY/ON button to turn on the HT-R490Speaker Setup Selecting the speaker configurationSetting the subwoofer mode Press the Test Tone button to complete adjustmentUsing Multi Channel Input Selecting a sound sourceStart playing the selected input source Selecting a sound source Memory FM Mode Preset 5/∞Listening to Radio Broadcasts Listening to FM/AM radio stationsPresetting a radio station Press the Memory button to finalize the procedureListening to Radio Broadcasts Tune into the radio station you desireTo enjoy Surround mode Dolby PRO Logic II surroundAnalog/PCM Pulse Code Modulation surround To enjoy Surround mode Relationship between input sources and surround modesDTS Surround Stereo DSP Input SelectorLate Night function During Dolby Digital surround playback, press the DSP buttonTo record the input source signal you are Recording a sourceCurrently watching or listening to Start recording at the recording component as desiredUsing remote controller CD ModeTape Mode Controlling an Onkyo CD playerUsing remote controller Pre-programming remote controller When entering the code of Onkyo DVD playersLearning a pre-programming code Controlling a DVD player ModePre-programming remote controller Code ListBrand Troubleshooting guide PowerTroubleshooting guide Remote ControllerFM/AM Tuner OtherSpecifications Remote ControlAmplifier Section Tuner Section Video Section