Bosch Appliances DVA-08K manual Subsystem Components, 2.3.1, LCD Panel

12 en IntroductionRAID Subsystem DVA-08K Installation Manual

2.3	Subsystem Components
	All the active components on the subsystem can be accessed through either the front or rear
	panel. The modular design of the active components facilitates their easy installation and
	removal. Hot-swap mechanisms are incorporated to eliminate power surges and signal
	glitches that might occur while removing or installing these modules.
2.3.1	LCD Panel

Fig. 2.6 Opening the Front Handle

The LCD panel shown in Figure 2.6 consists of a 16 characters x 2 rows LCD screen with push buttons, a mute button, and LED status indicators. The LCD front panel provides full access to all array configurations and monitoring. After powering up the subsystem, the initial screen will show the subsystem model name. A different name can be manually assigned to the sub- system or different drive arrays. This will enable easier identification in a topology consisting of numerous arrays.

Fig. 2.7 Front Panel Retention Latch

To access drive bays in the left- or right-hand side column, first flip the retention latches (see Figure 2.7) on the enclosure front handles, and then swing the handles to the left- and right- hand sides. To close the handles (see Figure 2.8), swing the handles toward the system; gen- tly press the handles until a click is heard. The latches will keep the handles in place.

Fig. 2.8 Closing the Front Handles

F.01U.027.797 V2 2008.08 Bosch Security Systems