Setting the Display Brightness
You can adjust the brightness of the AV receiver’s display.
1 Press RECEIVER once followed by DIMMER repeatedly to switch between: normal, dim, or dimmer brightness.
Tip
•(North American and Brazilian models) Alternatively, you can use the AV receiver’s DIMMER.
Displaying Source Information
You can display various information about the current input source as follows.
1 Press RECEIVER once followed by DISPLAY repeatedly to cycle through the available information.
Tip
• Alternatively, you can use the AV receiver’s DISPLAY.
The following information can typically be displayed.
Input source & volume*1
Listening mode
Signal format*2 or sampling frequency
*1 | When AM or FM radio is used, the band, frequency, and preset |
| number are displayed. |
*2 | If the input signal is digital, the signal format is displayed. |
| Information is displayed for about three seconds, then the |
| previously displayed information reappears. |
Turning On & Basic Operations
Changing the Input Display
When you connect an
This setting can be done only from the front panel.
1 Press TV/CD, GAME or VCR/DVR.
“TV/CD”, “GAME” or “VCR/DVR” appears on the AV receiver’s display.
2 Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input display.
■TV/CD: TV/CD → DOCK
→TAPE →
■GAME: GAME ↔ DOCK
■VCR/DVR: VCR/DVR ↔ DOCK
Note
•“DOCK” can be selected for the “TV/CD”, “GAME” or “VCR/DVR” input selector, but not at the same time.
•Enter the appropriate remote control code before using the remote controller for the first time (➔ page 55).