3M X80, X70 manual PICTURE-2 Menu, Position, Phase, Size, Over Scan

Multifunctional Settings (continued)

PICTURE-2 Menu

With the PICTURE-2 menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below.

memo This menu cannot be selected at a M1-D signal.

MENU

MAIN	V POSITION	20
PICTURE-1	H POSITION	142
PICTURE-2	H PHASE	31
INPUT	H SIZE	1344
AUTO	OVER SCAN	95
SCREEN	RESET
OPTION
NETWORK
: SELECT

Item		Description
	Adjust the vertical position using the /		buttons. :
V POSITION	Up	Down
	memo This item can be selected only at a RGB signal.
	Adjust the horizontal position using the		/ buttons. :
H POSITION	Left	Right
	memo This item can be selected only at a RGB signal.

Adjust the horizontal phase to eliminate flicker using the / buttons. :

H.PHASE

Right Left

memo This item can be selected only at a RGB signal or a component video signal other than a COMPONENT port input of 525i/625i/SCART RGB.

	Adjust the horizontal size using the		/	buttons. :
	Large	Small
H SIZE	memo This item can be selected only at a RGB signal.
	memo When this adjustment is excessive, the picture may not be displayed
	correctly. In such a case, please reset the adjustment pressing the RESET
	button during this operation.
	Adjust the over-scan ratio using the		/	buttons. :
	Small	Large
OVER SCAN	memo This item can be selected only at a video signal.
	memo When this adjustment is too large, certain degradation may appear at
	the frame area of the picture. In such a case, please adjust small.

Select the EXECUTE using the button to reset the PICTURE-2 menu items. :

RESET

EXECUTE CANCEL

The items of the PICTURE-2 menu are collectively returned to the initial setting. Note that the item “H PHASE” is not reset.

26