3M X70 manual Adjusting The Projectors Elevator, Using The Lens Shift Buttons X80 only

Setting Up (continued)

Adjusting The Projector's Elevator

WARNING • Do not touch about the lens and ventilation openings during use or immediately after use to prevent a burn.

CAUTION • To prevent damaging the projector and injuring yourself, always hold the projector whenever using the elevator buttons to adjust the elevator feet.

You can use the elevator feet to make adjustments if the surface on which you need to set the projector is uneven or if you otherwise need to adjust the angle of projection. The adjustment range of the elevator feet is 0 to 9 degrees.

1	Press and hold in the elevator buttons.
	Raise or lower the projector to the desired height and
2
	then release the elevator buttons.
	When you release the elevator buttons, the elevator
	feet will lock into position.
	As necessary, you can also finely adjust the height of
3
	the projector by twisting the elevator feet by hand.

Elevator buttons

Elevator feet

Using The Lens Shift Buttons (X80 only)

NOTE • Generally, better quality of a picture is available when the lens shift is set to the center.

The lens of this projector can be shifted vertically. When you want to finely adjust the picture position, use the LENS SHIFT buttons of the projector.

lens shift

LASER INDICATOR

STANDBY/ON VIDEO RGB

LENS SHIFT buttons	+	+	+
	LENS SHIFT FOCUS ZOOM
	–	–	–

BLANK ASPECT LASER

10:0 (max)

1:1(min)

Projector Remote control

7