3M S40, X40 manual Turning OFF the Power, Press the STANDBY/ON button of remote

Page 17

TURNING OFF THE POWER

 

STANDBY/ON

VIDEO

RGB SEARCH

ASPECT

AUTO BLANK

MAGNIFY

VOLUME

ON

 

 

MUTE

OFF

 

FREEZE

KEYSTONE

POSITION

MENU

 

ENTER

ESC

RESET

1

Press the STANDBY/ON button of remote

 

controrol or the on/off button of control panel

The message "Power off?" will appear on the screen for approximately 5 seconds.

2

Press the STANDBY/ON or on/off button

 

again(remote control or control panel)

Press the STANDBY/ON or on/off button again while the "Power off?" message is visible. The projector lamp goes off and starts cooling down. The power indicator blinks orange while the lamp cools down. (Pressing the STANDBY/ON or on/off button while the power indicator is blinking orange has no effect.)

The system goes into the STANDBY mode after cooling down and the power indicator stops blinking orange and then lights to solid orange.

Control panel

on off

video rgb

reset

lamp

keystone

temp

power

menu

NOTE

Except in emergencies, follow the above- mentioned procedure for turning power off.

3 Check that the power indicator stops blinking and lights to solid orange. Switch the power switch to [O] (OFF).

When the projector has

 

completed powering down,

power switch

the power indicator will go off.

power indicator

16

Image 17
Contents S40/X40 Multimedia Projector S40/X40 Multimedia Projector Operators Guide ContentsCable Projector FeaturesPower cord Connect your devices to the projector Projector Part NamesTerminal Panel Adjusting the Projectors Elevator Foot Setting UP the ProjectorIf 43 aspect ratio Adjusting the Screen Size and Projection DistanceConnecting Your Devices Function Projector Port Connection Cables Ports and CablesConnecting to a Computer Connecting Your DevicesConnecting to a VCR Connecting to a DVD PlayerPutting batteries into the remote control unit Using the Remote ControlRemove the battery cover Close the battery coverOperating the remote control Precautions Turning on the PowerMake sure that the power cord is firmly Turn on the projectors powerUse the zoom ring to adjust Selecting an Input SignalScreen size Use the focus ring to focus the pictureAgainremote control or control panel Turning OFF the PowerPress the STANDBY/ON button of remote Controrol or the on/off button of control panelPress the Volume button Adjusting the VolumePress Buttons to adjust Volume Temporarily Muting the SoundPress the Position button Adjusting the PositionUse Buttons to adjust Position Automatic Adjustment for RGB Input Using the Automatic Adjustment FeatureAutomatic Adjustment for Video Input Press the Auto buttonPress the Keystone button Correcting Keystone DistortionsUse the , buttons to correct DistortionFreezing the Screen Using the Magnify FeatureTemporarily Blanking the Screen Signal SearchingSelecting the Aspect Ratio Select a menu using Buttons Then press Or Enter button Using the Menu FunctionsSelect an item using Buttons, then press Or Enter button Press Buttons to adjust the levelMain Menu Multifunctional SettingsMain Menu PICTURE-2 Menu PICTURE-1 MenuPICTURE-1 Menu PICTURE-2 MenuInput Menu Input MenuAuto VideoScreen Menu Screen MenuBlank Start UPOption Menu Option MenuAuto OFF WhisperLamp High Voltage High Temperature High PressureLeast 45 minutes, and prepare a new Replacing the lampAir Filter AIR FilterCaring for the air filter Replacing the air filter Other Care Caring for the cabinet and remote control transmitterCaring for the inside of the projector Caring for the lensRelated Messages Power Lamp Temp Description Regarding the Indicator LampsItems to be confirmed Phenomena That May Easily Be Mistaken for Machine DefectsPhenomenon Specification SpecificationsDimension Diagram Part Number How to OrderDN00571 S30/X40OGENG