3M S40, X40 manual Setting UP the Projector, Adjusting the Projectors Elevator Foot

Page 7

SETTING UP THE PROJECTOR

CAUTION • Install the projector in a suitable environment according to instructions of the “Product Safety Guide” and this manual "Operator's Guide".

If you press the elevator button without holding the projector, the projector might crash down, overturn, smash your fingers and possibly result in malfunction. To prevent damaging the projector and injuring yourself, ALWAYS HOLD THE PROJECTOR whenever using the elevator button to adjust the elevator foot.

Adjusting the Projector's Elevator Foot

You can use the elevator foot to make adjustments if the surface on which you need to set the projector is uneven or if you otherwise need to adjust the angle of projection. The adjustment range of the elevator foot is 0 to 9 degrees.

1 Pressbutton and hold in the elevator

Raise or lower the projector to the

2 desired height and then release the elevator button

When you release the elevator button, the elevator foot will lock into position.

3

As necessary, you can also finely

 

adjust the left-right slope of the

 

 

projector by twisting the rear foot

 

 

adjuster screw by hand

9

Rear Foot Adjuster

6

Image 7
Contents S40/X40 Multimedia Projector S40/X40 Multimedia Projector Operators Guide ContentsPower cord Projector FeaturesCable Connect your devices to the projector Projector Part NamesTerminal Panel Adjusting the Projectors Elevator Foot Setting UP the ProjectorIf 43 aspect ratio Adjusting the Screen Size and Projection DistanceConnecting Your Devices Function Projector Port Connection Cables Ports and CablesConnecting to a Computer Connecting Your DevicesConnecting to a VCR Connecting to a DVD PlayerClose the battery cover Using the Remote ControlPutting batteries into the remote control unit Remove the battery coverOperating the remote control Turn on the projectors power Turning on the PowerPrecautions Make sure that the power cord is firmlyUse the focus ring to focus the picture Selecting an Input SignalUse the zoom ring to adjust Screen sizeControrol or the on/off button of control panel Turning OFF the PowerAgainremote control or control panel Press the STANDBY/ON button of remoteTemporarily Muting the Sound Adjusting the VolumePress the Volume button Press Buttons to adjust VolumeUse Buttons to adjust Position Adjusting the PositionPress the Position button Press the Auto button Using the Automatic Adjustment FeatureAutomatic Adjustment for RGB Input Automatic Adjustment for Video InputDistortion Correcting Keystone DistortionsPress the Keystone button Use the , buttons to correctFreezing the Screen Using the Magnify FeatureSelecting the Aspect Ratio Signal SearchingTemporarily Blanking the Screen Press Buttons to adjust the level Using the Menu FunctionsSelect a menu using Buttons Then press Or Enter button Select an item using Buttons, then press Or Enter buttonMain Menu Multifunctional SettingsMain Menu PICTURE-2 Menu PICTURE-1 MenuPICTURE-2 Menu PICTURE-1 MenuVideo Input MenuInput Menu AutoStart UP Screen MenuScreen Menu BlankWhisper Option MenuOption Menu Auto OFFLamp High Voltage High Temperature High PressureLeast 45 minutes, and prepare a new Replacing the lampCaring for the air filter AIR FilterAir Filter Replacing the air filter Caring for the lens Caring for the cabinet and remote control transmitterOther Care Caring for the inside of the projectorRelated Messages Power Lamp Temp Description Regarding the Indicator LampsPhenomenon Phenomena That May Easily Be Mistaken for Machine DefectsItems to be confirmed Dimension Diagram SpecificationsSpecification Part Number How to OrderDN00571 S30/X40OGENG