Section 3: Basic Operations
3.1 Projector Startup
FOCUS | ZOOM |
CLOSE
OPEN
Figure 3.1 Projector Controls
1.Make all cable connections and line hookups with the power off.
2.Turn the POWER SWITCH of the projector on. The ON indicator will light up orange.
| CLOSE |
3. Move the LENS SHUTTER CONTROL | to the open position. |
OPEN
4.Press the STANDBY/ON button 
. The ON indicator blinks (green) and then lights (green). The ON indicator will blink green during
5.Adjust the screen size using the ZOOM button 
ZOOM 
.
6.Adjust the focus using the FOCUS button 
FOCUS
.
A)Press the FOCUS button. The
B)Adjust the focus so that the picture is sharp using the FOCUS button.
7.Turn on all connected equipment. The method of connecting various equipment, see section 2.3.
8.Press the INPUT button 
on the projector or the INPUT SELECT (VIDEO or RGB) button on the remote to select the source of the signal to be projected on the screen. The selected signal input is displayed at the bottom right of the screen. The display will show the last selected input source before power was turned off.
3.2 Projector Shutdown
1. Hold the STANDBY/ON button 
for
2.Turn the MAIN POWER SWITCH 
of the projector off.
Caution
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is pressed, the fan rotates for about 1 minute to cool the projector.
CLOSE
3. Close the LENS SHUTTER . Push up on the lens cover switch to close.
OPEN
4.Disconnect cables.
© 3M 1999 | 3M™ Multimedia Projector MP8740 | 7 |