ENGLISH
3
3. Remove lamp module: Grasp the lamp module with hand and the projector body with the other hand.
Carefully slide the lamp module out (3) using steady pressure.
4. Insert lamp module: Carefully insert the new lamp module. Ensure that it is fully seated.
Tighten the lamp module retaining screws to secure the lamp module in place.
Insert the hinge tabs on the left side of the lamp access door, then close and tighten the retaining screws to secure the door.
Figure 6.2 Lamp Module
✔Note
Reset the lamp operation hours. See section 6.2 for details.
16 | 3M™ Multimedia Projector MP8740 | © 3M 1999 |