Safety Instructions
Safety Instructions
Please take note of the safety instructions to prevent any potential accident or misuse of the projector.
➟Safety Instructions are given in two forms as detailed below.
WARNING : The violation of this instruction may cause serious injuries and even death.
NOTES : The violation of this instruction may cause light injuries or damage to the projector.
➟ After reading this manual, keep it in the place that the user always can contact easily.
Indoor Installation
Do not place the Projector in direct sunlight or near heat sources such as radiators, fires and stove etc.
This may cause a fire hazard !
WARNING
Do not place inflammable materi- | Do not allow children to hang on | |
als beside the projector | the installed projector. | |
This may cause a fire hazard ! | It may cause the projector to fall, caus- | |
ing injury or death. | ||
|
| Indoor Installation | NOTES |
|
|
|
Disconnect from the mains and remove all connections before moving.
Do not place the projector close to sources of steam or oil such as a humidifier.
This may create a fire hazard or an electric shock hazard !
Do not place the projector where it might be exposed to dust.
This may cause a fire hazard or damage to the unit!
When installing the projector on a table, be careful not to place it near the edge.
This may cause the projector to fall causing serious injury to a child or adult and serious damage to the projector.
Only use a suitable stand.
Only use the projector on a level and stable surface.
It may fall and cause injury and/or damage to the unit.
Ensure good ventilation around the projector. The distance between the projector and the wall should be more than 20cm/8 inches.
An excessive increase in its internal temperature may cause a fire hazard or damage to the unit!
Do not block the vents of the pro- jector or restrict
This would cause the internal tempera- ture to increase and could cause a fire hazard or damage to the unit!
Do not place the projector directly on a carpet, rug or place where ventilation is restricted.
This would cause its internal temperature to increase and might create a fire hazard or damage the unit.
| Outdoor Installation | WARNING |
|
|
|
Do not use the projector in a damp place such as a bathroom where it is likely to get wet.
This may cause a fire or an electric shock hazard !
| Power | WARNING |
|
|
|
Earth wire should be connected.
If the earth wire is not connected, there is a possible danger of electric shock caused by the current leakage.
If grounding methods are not possible, a separate circuit breaker should be installed by a qualified electrician.
Do not connect ground to telephone wires, lightning rods or gas pipe.
The mains plug should be inserted fully into the power outlet to avoid a fire hazard !
This may cause a fire hazard or damage the unit.
Do not place heavy objects on the power cord.
This may cause a fire or an electric shock hazard !
4