Information
Supported Monitor Display
* The following table lists the display formats supported by the projector.
Sources | Format | Vertical Freq.(Hz) | Horizontal Freq.(kHz) |
*If the projector does not support the input signal, “Out of Range” message appears on the screen.
*The projector supports DDC1/2B type as Plug & Play function. (Auto recognition of PC monitor)
*The Synchronization input form for horizontal and vertical frequencies are Separate.
*According to PC, the optimum vertical frequency may not be displayed up to the optimum frequency of set in ‘Registration information (Display registration information)’. (ex, The optimum vertical frequency may be displayed up to 85Hz or under in the resolution of 640X480 or 800X600.)
*In case of the use of HDMI to HDMI cable, PC shall not be supported.
<DVD/DTV Input>
Signal |
|
| |||
|
|
|
|
| |
| 480i | O | X | X | |
|
|
|
|
| |
NTSC(60Hz) | 480p | O | O | O | |
|
|
|
| ||
720p | O | O | O | ||
| |||||
|
|
|
|
| |
| 1080i | O | O | O | |
| 576i | O | X | X | |
PAL(50Hz) | 576p | O | O | O | |
|
|
|
| ||
720p | O | O | O | ||
| |||||
| 1080i | O | O | O | |
* Cable type
1- RGB to Component Cable
2- Computer Cable
3- HDMI Cable
* Recomended 720p for a better image.
Maintenance
*The projector needs little maintenance. You should keep the lens clean because any dirt or stains may appear on the screen. If any parts need to be replaced, contact your dealer. When cleaning any part of the projector, always turn the power off and unplug the projector first.
Cleaning the lens
If there is any dust or stain on the surface of the lens, you must always clean the lens. Use an air sapray or cleaning cloth for product exterior, provid- ed with the product, to lightly clean the product. When you want to remove dust or stain on the lens, use the air spray or choth for product exterior, pro- vided with the product, with neutral detergent and water.
Cleaning the Projector Case
To clean the projector case, first unplug the power cable. To remove dirt or dust, wipe the casing with polish cloth provided. When you want to remove the dust or stain on the lens, use the cloth for product exterior, provided with the product.
Do not use alcohol, benzene, thinners or other chemical detergents as these can cause the casing to be warped or discolored.
24