Mitsubishi Electronics WL6700U Viewing computer images, Connecting the projector to a computer

Page 13

Viewing computer images

A. Connecting the projector to a computer

Preparation:

•Make sure that the power of the projector and that of the computer are turned off.

•When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.

Computer

COMPUTER/

1

COMPONENT

VIDEO IN 2

2

To monitor port

RGB cable

Computer

For analog connection:

(For using the COMPUTER/COMPONENT VIDEO IN 2 terminal.)

1.Connect one end of the supplied RGB cable to the COMPUTER/COMPONENT VIDEO IN 2 terminal of the projector.

2.Connect the other end of the RGB cable to the monitor port of the computer.

•When viewing images supplied from an analog-connected computer, press the COMPUTER 2 button on the remote control.

R/PR G/Y B/PB H/HV

V

COMPUTER/ 1

 

COMPONENT

 

VIDEO IN 1

To monitor

 

port (5 BNC)

For analog connection:

(For using the COMPUTER/COMPONENT VIDEO IN 1 terminal.)

1.Connect one end of a commercially available BNC cable to the COMPUTER/COMPONENT VIDEO IN 1 terminal of the projector.

V H/HV B/PB G/Y R/PR

BNC cable (option)

22. Connect the other end of the BNC cable to the 5 BNC terminals of the monitor port of the computer.

•When viewing images supplied from an analog-connected computer, press the COMPUTER 1 button on the remote control.

Computer

COMPUTER/

1

COMPONENT

 

VIDEO DVI-D(HDCP)

 

2

 

 

To DVI

 

 

 

 

DVI cable (option)

Computer

1

AUDIO IN 1/2

AUDIO OUT

PC audio cable (option)

To audio output

2 terminal

For digital connection:

1.Connect one end of a commercially available DVI cable to the COMPUTER/COMPONENT VIDEO DVI-D(HDCP) terminal of the projector.

2.Connect the other end of the DVI cable to the DVI terminal of the computer.

•When viewing images supplied from a digital-connected computer, press the DVI-D(HDCP) button on the remote control.

•Turn on the main power switch of the projector before starting the computer.

For audio connection:

1.Connect one end of a commercially available PC audio cable to the AUDIO IN 1/2 terminal of the projector.

2.Connect the other end of the PC audio cable to the audio output terminal of the computer.

•This projector uses stereo pin jack for its audio input. Check the type of the audio output terminal of the connected computer and prepare a proper cable for connection. Some computers don’t have the audio output terminal.

•Speaker output is mono.

•Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending on the type of the computer to be connected.

•Use of a long cable may decrease the quality of projected images.

•Images may not be projected correctly, depending on the type of the connected computer.

•When DVI-D signal is input, some signal setting menus are unavailable.

•Also read the instruction manual of the equipment to be connected.

•Contact your dealer for details of connection.

EN-13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents WL6700 Compliance Notice When using the projector in EuropeContents Important safeguards Important safeguards Inserting the batteries into the remote control Checking accessoriesPreparing your projector Overview Preparating your projectorControl area Terminal board Adjustment feet Air inlet grille/Filter cover Lamp cover Bottom side Remote controlHow to disable the Laser button How to enable the Laser buttonOperational range of the remote control Using the remote controlUsing the wired remote control Reception angleSetting up the screen Setting up your projectorWhen the aspect ratio is Full Display at 1366 x 800 pixels Screen size and projection distanceAdjusting the projection angle Setting up your projectorWhen fine streaks are seen on projected images When projected images are distorted to a trapezoidRear projection Front projection, ceiling mountingViewing computer images Connecting the projector to a computerViewing computer images Plugging the power cordFor monitor connection For audio output connectionRemove the lens cap Projecting imagesExample of the setting procedure for external output When connecting to a notebook computerTo stop projecting AV muteHow to change the settings With the remote control Setting the aspect ratioWith the Feature menu To cancel the menuConnecting to a video player, etc Connecting the projector to video equipmentViewing video images Projector + DVD player or Hdtv decoder Viewing video imagesConnection for video equipment having an Hdmi terminal Connection for video equipment having a DVI-D terminal Plugging in the power cordEN-21 Volume from the speaker Menu operation SetupAvailable settings in the menus How to set the menusMenu operation EN-25 EN-26 EN-27 EN-28 To adjust the brightness Contrast and Brightness Adjusting projected imagesTo adjust the color Color and Tint To sharpen or soften the projected image SharpnessTo adjust the tone of white Color Temp Adjusting projected imagesAbout color temperature Color EnhancerYES How to adjust the computer imageTo adjust the horizontal position Simple method to adjust the image positionTo adjust the vertical position LPF Progressive filterSetting procedure Advanced featuresSet the background color Set the image sizePassword function Advanced featuresTo cancel the password function To enable the password functionMagnifying the displayed image SplitFreeze Projector + computer with USB connector Mouse remote controlOperation Up buttonProjectorView Supervising and controlling by computerPJLink About PJLinkNormal condition IndicatorsProcedure for setting the anti-theft alarm device Terminal cover with anti-theft alarm deviceProcedure for changing batteries Replacing the lamp Interval of lamp replacementReplacing the lamp Reset of the lamp operation timeTo replace the lamp Cleaning of the air-filter MaintenanceCleaning of the projector and the ventilation slots Cleaning of the lensNo image appears on the screen TroubleshootingNo image appears on the screen Problem Solution TroubleshootingImages are not displayed correctly Problem Solution Kensington Lock Others Problem SolutionSpecifications Replacement part option/not included in the boxXGA85 SpecificationsDimension drawings unit mm ConnectorsWithout terminal cover With terminal cover Mitsubishi Projector Contact Information
Top Page Image Contents