Mitsubishi Electronics WL2650 Preparating your projector, Overview, Control area, Terminal board

Preparating your projector (continued)

Overview

1

2

3

4

5

6

7

8

9

13 12 11 10

1Speaker

2Air inlet grille/Filter cover

3Control area

4ZOOM ring

5FOCUS ring

6Remote control sensor (Front)

7Air outlet grille

8Lamp cover

9Air outlet grille

10Remote control sensor (Rear)

11Kensington Security Lock Standard connector

12Lock bar (SECURITY ANCHOR)

• Attach a chain, etc. to this lock bar to anchor the projector.

13Terminal board

Caution:

Do not replace the lamp immediately after using the projector because the lamp would be extremely hot and it may cause burns.

Control area

1	1	COMPUTER/W button
	2	AUTO POSITION/S button
	3	VIDEO/X button
2	4	KEYSTONE/ENTER button
	5	VOLUME/T button
3	6	MENU button
	7	POWER button
	8	POWER indicator
4	9	STATUS indicator

9 8 7 6 5

Important:

•While the menu or the screen for the keystone adjustment or password entry is being displayed or image captur- ing is being executed, the COMPUTER, VIDEO, AUTO POSITION and VOLUME buttons function as the W, X, S and T buttons respectively.

•While the menu is on the screen, the KEYSTONE button functions as the ENTER button.

Terminal board

13

12

11

		1	COMPUTER/COMPONENT VIDEO IN-1 terminal (Mini
1 2	3		D-SUB 15-pin)
		2	COMPUTER/COMPONENT VIDEO IN-2 terminal (Mini
			D-SUB 15-pin)
		3	COMPUTER/COMPONENT VIDEO DVI-D (HDCP) termi-
			nal (DVI-D 24-pin)
	4	4	LAN terminal
		5	SERIAL terminal (D-SUB 9-pin)
	5	6	USB (COMPUTER) terminal
	6	7	Power jack
	7	8	Air inlet grille

9MONITOR OUT terminal (Mini D-SUB 15-pin)

10AUDIO OUT terminal (Mini jack)

10	8	11	AUDIO IN-1 and AUDIO IN-2 terminals (Mini jack)
			• The AUDIO IN-1 terminal is used for both COMPUTER 1
9			and DVI input.
		12	S-VIDEO IN terminal and audio input terminals
		13	VIDEO IN terminal and audio input terminals

EN-7