Basic operation (continued)
6.Adjust the image size by turning the zoom ring.
7.Adjust the vertical position of the displayed image by turning the LENS SHIFT dial.
• If necessary, adjust the focus and zoom again.
When fine streaks are seen on projected images
This is due to interference with the screen surface and is not a malfunction. Replace the screen or displace the focus a little.
Power-off
Use the following procedure to turn off the projector. The lamp may deteriorate if the projector is powered off and on repeatedly within 30 minutes after the lamp is lighted.
1.Press the POWER button on the control panel or the STANDBY button on the remote control.
•The message “Power Off? Press 
again” appears on the screen.
•To cancel, press any button except the POWER button.
(Some buttons on the remote control don’t function for cancel.)
2.Press the POWER button on the control panel or the STANDBY button on the remote control within
10 seconds again.
•The lamp will go out and the STATUS indicator will start blinking.
3.Wait about 90 seconds for the STATUS indicator to be turned off.
4.Unplug the power cord.
•The POWER indicator will go out.
•If the power cord should be unplugged accidentally while either the STATUS indicator is blinking or the lamp is on, allow the projector to cool down for 10 minutes with the power off. To light the lamp again, press the POWER button (or ON button). If the lamp doesn’t light up immediately, repeat pressing the POWER button (or ON button) two or three times. If it should still fail to light up, replace the lamp.
Important:
•When storing the projector in the carrying case, the lens should face up.
Before carrying the projector, rotate the focus ring and zoom ring to adjust the lens to the shortest. This prevents the possible damages of the lens.
Direct Power OFF
You can turn off this projector just by unplugging the power cord without pressing the POWER button.
•Don’t shut down the projector while the STATUS indicator is blinking after the lamp lights up because the lamp’s life may be shortened.
•Don’t turn the projector back on right after shutting it down because the lamp’s life may be shortened.
(Wait about 10 minutes before turning the projector back on.)
•Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without closing the menu, the setting data of the menu may not be saved.
•If you shut down the projector while controlling the projector using the network function, the application software such as ProjectorView may fail. For details, see “User Manual of LAN Control Utility” contained in the
AUTO POSITION button
When the image isn’t projected in the right position with Computer selected as the input source, follow the procedure below.
1.Project a bright image such as the “Recycle Bin” window on the full screen.
2.If the screen saver is running, turn it off.
3.Press the AUTO POSITION button.
•If the image is still not in the right position, adjust the image position using the Signal menu. See page 25.
Volume from the speaker
Press the VOLUME or button to change the volume from the speaker.
The volume control bar will appear on the screen.
|
|
| Volume |
|
|
|
|
|
|
|
|
|
|
| 16 |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•The volume control bar will disappear about 10 seconds after the VOLUME button is released.
•The VOLUME buttons don’t function while the menu is being displayed.
•When a
You can change the volume also by using the Volume setting in the Audio menu.
(See page 22 for menu setting.)
1.Display the Audio menu.
2.Select Volume by pressing the or button.
3.Adjust the volume by pressing the or button.
4.Press the MENU button to exit the menu.
AV mute
The video and audio signals are temporarily muted when the AV MUTE button is pressed. To cancel muting, press the AV MUTE button again.