Mitsubishi Electronics XD8100U manual PC-controllable functions, Connection, Command

Page 1

DLP™ Projector

XD8100U

Controlling the projector using a personal computer

This projector can be controlled by connecting a personal computer with RS-232C terminal.

In addition, by connecting multiple projectors to each other in a daisy chain configuration, you can control each projector from one personal computer.

PC-controllable functions:

Turning the power ON or OFF

Changing input signals

Inputting commands by pressing the buttons on the control panel and remote control

Menu setting

[Compatibility with the former models]

To use the RS-232C commands designed for the former models of Mitsubishi projector, by inputting “00COMMAND0”, the projector responds in the same way as the former models. (No NAK is returned. ID code cannot be designated at command sending.)

(For the recommended procedure to use the former command systems, see “Controlling the projector using a personal computer” for FL7000U.)

ITEM

 

Function

Data

Character

ASCII code

 

 

Changing the RS-232C

COMMAND

43h 4Fh 4Dh 4Dh 41h 4Eh 44h

0 (Former command system), 1 (New

command system

 

 

command system)

Connection

Important:

Make sure that your computer and projector are turned off before connection.

Boot up the computer first, and then plug the power cord of the projector. (If you do not follow this instruction, the Com port may not function.)

To use a daisy chain configuration, make sure to use Mitsubishi projectors supporting RS-232C communication. If the projectors or other devices made by other manufacturers are connected, operation is not guaranteed.

To connect with one projector:

To RS-232C terminal

 

To SERIAL IN

RS-232C cable

terminal

 

D-SUB 9-pin

D-SUB 9-pin

 

To connect with multiple projectors (in a daisy chain configuration):

To RS-232C terminal

 

To SERIAL IN

To SERIAL OUT

 

To SERIAL IN

To SERIAL OUT

RS-232C cable

terminal

terminal

RS-232C cable

terminal

terminal

 

 

 

 

D-SUB 9-pin

D-SUB 9-pin

 

D-SUB 9-pin

D-SUB 9-pin

 

1

Image 1
Contents PC-controllable functions CommandCompatibility with the former models ConnectionCommunications format ACK/NAK Control command configurationCommand for Power on is sent to Method of checking state of projector RS-232C control flowchartEND Reading command diagram Command list Operation commandsLamp 1 Time LOW ResolutionLamp 2 Time LOW Next Lamp RelayZOOM/FOCUS Super ResolutionLens Shift GeometryHORIZ. Curved ARC VERT. Curved ARC KSHBright Uniformity KsrstMULTI-SCREEN Gamma Mode Color Enhancer CEU2B USER-GAMMA Mode Color Enhancer CEU1BSuper Resolution DHD Super Resolution DhdlvAuto Power on Apon Lens Shift Reset LsrstAuto Power OFF Apof Mode DVI Long Cable DviclvManual Reset Color Matching Msml Reset Color Matching CMCMeasure Reset Aspect ALL SIGNALS, 1 Video onlyCinema Mode Password Function PslockVideo Signal SET UP STU00APON1 00CEU1GS2 Pass Password lock commandsExecution procedure of RS-232C commands via LAN