Mitsubishi Electronics XD530U Changing the settings for the projection, Changing the password

How to use the administration screen (continued)

Glossary

TCP/IP	Transmission Control Protocol/Internet Protocol
	(TCP/IP) is the standard protocol used for network-
	ing. Protocol is a set of technical rules for the trans-
	mission of information between computers.
IP Address	IP Address is the numbered address to identify a
	server for networking. Internet Protocol (IP) is the
	protocol to transmit data over the Internet, and the IP
	Address, which consists of exactly same numbers as
	the other address in one network, is not available.
DHCP	Dynamic Host Configuration Protocol (DHCP) is the
	protocol dynamically allocating IP addresses to com-
	puters on a local area network. The computer with
	DHCP server can assign IP address to each com-
	puter on a local area network automatically.
Subnet Mask	Subnet is the separated part of network, and subnet
	mask is a number that defines a range of IP
	addresses that can be used in the network.
Gateway	Gateway is either hardware or software that acts as
	a bridge between two networks. Gateway is a sys-
	tem for transmitting data across networks that are
	incompatible and use different protocols.
WEP	Wired Equivalent Privacy (WEP) is a security proto-
	col that adds security by encrypting data. The
	encryption key enables only the authorized systems
	on the network to recognize the data.
SSID	Service Set ID (SSID) is the identifier for wireless
	local area networks, which identifies the access
	points necessary for transmitting. Some wireless
	local area network card uses [ESSID (Extended Ser-
	vice Set Identifier)] or network name as SSID.

Changing the settings for the projection

You can change the settings for the number of colors and the login code.

1.Click "Projection Setup".

2.Change the settings, then click the [Apply] button.

EN-28

•You can change the following settings.

Settings	Contents
Resolution	The resolution of this projector is fixed at XGA.
	You can specify the number of colors for the pro-
Color Depth	jected images.
	You can select "Normal (16 bit) (65,536 colors)
	or "High (32 bit)" (16,777,216 colors).
Screen Refresh Rate	The rate of this projector is fixed at 75 Hz.
	You can specify the login code to connect to the
	projector wirelessly.
	•	Disable: You can connect to the projector wire-
Login Code		lessly without entering the login code.
	•	Random: The login code is changed randomly
		each time the projector starts up. (Default)
	•	Use the following code: Specify the login code.
		The login code is a four-digit number.

3. Check the displayed settings, then click the [OK] button.

4. Reboot the system.

• The specified settings can be applied.

• It takes approximately one minute to reboot the system.

Changing the password

You can change the passwords for the user (trainer) and administrator (admin).

1.Click "Change Passwords".

2.Enter a new password in "Conference Control" or "Admin", and then click each [Apply] button.

Restoring the default settings

You can restore the default settings.

1.Click "Reset to Default".

2.Click the [Apply] button.

3.Check the displayed settings, then click the [OK] button.

4.Reboot the system.

•The default settings can be restored.

•It takes approximately one minute to reboot the system.