Viewing computer images

A. Connecting the projector to a computer

Preparation:

•Make sure that the power of the projector and that of the computer are turned off.

•When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.

Computer

COMPUTER/

COMPONENT 1

VIDEO IN-1

2 To monitor port

RGB cable

Computer

R/PR G/Y B/PB H/HV V

COMPUTER/COMPONENT 1 VIDEO IN-2

To monitor port (5 BNC)

V H/HV B/PB G/Y R/PR

BNC cable (option)

Computer

COMPUTER/	1
COMPONENT	1
VIDEO DVI-D IN
(HDCP)

To DVI

DVI cable (option)

For analog connection:

(For using the COMPUTER/COMPONENT VIDEO IN-1 terminal.)

1.Connect one end of the supplied RGB cable to the COMPUTER/COMPONENT VIDEO IN-1 terminal of the projector.

2.Connect the other end of the RGB cable to the monitor port of the computer.

•When viewing images supplied from an analog-connected computer, press the COMPUTER 1 button on the remote control.

For analog connection:

(For using the COMPUTER/COMPONENT VIDEO IN-2 terminal.)

1.Connect one end of a commercially available BNC cable to the COMPUTER/COMPONENT VIDEO IN-2 terminal of the projector.

2.Connect the other end of the BNC cable to the 5 BNC terminals of the monitor port of the computer.

•When viewing images supplied from an analog-connected computer, press the COMPUTER 2 button on the remote control.

For digital connection:

1.Connect one end of a commercially available DVI cable to the COMPUTER/COMPONENT VIDEO DVI-D IN (HDCP) terminal of the projector.

2.Connect the other end of the DVI cable to the DVI terminal of the computer.

•When viewing images supplied from a digital-connected computer, press the DVI-D(HDCP) button on the remote control.

•Turn on the main power switch of the projector before starting the computer.

Computer

AUDIO IN-1/2

AUDIO OUT

PC audio cable

(option) 2 To audio output terminal

For audio connection:

1.Connect one end of a commercially available PC audio cable to the AUDIO IN-1/2 terminal of the projector.

2.Connect the other end of the PC audio cable to the audio output terminal of the computer.

•This projector uses stereo pin jack for its audio input.

Check the type of the audio output terminal of the connected computer and prepare a proper cable for connection. Some computers don’t have the audio output terminal.

•Speaker output is mono.

•No audio is output from the projector’s speaker and the

AUDIO OUT terminal during power standby.

•Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending on the type of the computer to be connected.

•Use of a long cable may decrease the quality of projected images.

•Images may not be projected correctly, depending on the type of the connected computer.

•When DVI-D signal is input, some signal setting menus are unavailable.

•Also read the instruction manual of the equipment to be connected.

•Contact your dealer for details of connection.

EN-13