To operate projector power ON
2 • 9
VIDEO 1 | VIDEO 2 | COMPUTER 1 IN |
IN | IN |
|
MAIN |
| AUDIO OUT | |
|
| ||
AC IN | VIDEO |
|
|
|
|
| |
| COMPUTER | COMPUTER 2 / COMPONENT IN | COMPUTER OUT |
| AUDIO IN |
|
|
| AUDIO |
|
|
3•7•8
4
MUTE button
POWER MUTE
COMPUTER VIDEO
MOUSE LASER
ENGLISH
AUTO POSITION button
3•7•8 | POWER LAMP/TEMP |
| STATUS |
COMPUTER | KEYSTONE |
| AUTO POSITION |
POWER | POSITIONAUTO + |
| |
VIDEO | – | 4 | button |
| |||
|
|
|
MENU | ENTER / STILL |
AUTO POSITION | PinP |
KEYSTONE EXPAND
–KEYSTONE +
–VOLUME +
1.Turn on the equipment connected to the projector.
2.Put the projector into standby mode by pressing the main power switch. The POWER indicator lights up red.
3.Turn the projector on by pressing the POWER but- ton. The light source lamp starts warming up, even- tually turning completely on.
•When the light source lamp does not light up, wait until the STATUS indicator is turned off, then press the POWER button again.
•If the main power switch to the unit is turned off within two minutes of turning off the light source lamp, power will not be applied to the lamp for one minute when the next time the main unit power switch is turned on. When this happens, the STATUS indicator will blink for one minute.
Condition | Indicator | STATUS | POWER |
|
|
| |
|
|
|
|
| - | Red | |
When light source lamp is on | Green | Green | |
Light source lamp held off temporarily | - | Red | |
Important:
•A darkened image may be seen right after pressing the POWER button due to warming up of this pro- jector. While warming up, no other commands can be accepted.
•After the power is turned on, the screen may flicker before the lamp operation becomes stable. This is due to the characteristics of the lamp, not a failure of the lamp.
•When the STATUS indicator is blinking red, the lamp should be replaced. Replace the lamp. See
pages 22 and 23 | . |
•The picture might not be of optimum performance in extreme hot or cold conditions. (The projector is not malfunctioning.)
4.Select the desired external input source by using the COMPUTER or VIDEO button.
•The COMPUTER or VIDEO button does not work when MENU is displayed. At this time, the prohibi- tion mark (
) appeares on the screen.
•The projector automatically selects the appropriate signal format. The selected signal format is dis- played on the screen.
•When selecting the COMPUTER input, the image may flicker. Press the $ or % button to adjust the image.
5.Adjust the image size with the zoom ring by turning it.
6.Adjust the focus with the focus ring by turning it.
| focus ring |
far | near |
tele | wide |
zoom ring
EN – 13