Mitsubishi Electronics HC900 Using the remote control, Operational range of the remote control

Page 9

Using the remote control

Operational range of the remote control

ENGLISH

Front of projector	Rear of projector

30˚

30˚

30˚

30˚

Operate the remote control within a distance of 10 m from the projec- tor, pointing the light beam at the remote control photo-sensor (front or rear) of the projector.

•Keep the remote control photo-sensor out of direct sunlight or fluorescent lamp light.

•Keep the remote control photo-sensor at least 2 m away from fluorescent lamps. Otherwise, the remote control may malfunction.

•If there is an inverter-operated fluorescent lamp near the remote control, the remote control operation may become unstable. On this occasion, stick the attached protection sticker on one of the photo-sensors that is closer to the fluorescent lamp.

When operating the remote control, keep the distance from the remote controller to the projector via the screen within about 5m. The operable range of the remote control, however, depends on the characteris- tics of the screen.

Reception angle

Vertical directions

20˚

10˚

Vertical directions (ceiling mount)

20˚

20˚

10˚

20˚

EN-9

Image 9

Contents HC900 Compliance Notice When using the projector in EuropeContents Important safeguards Never remove the cabinet Place of installationDo not modify this equipment Do not block the air inlet and outlet grillesPreparating your projector Checking accessoriesInserting the batteries into the remote ControlControl area OverviewTerminal panel ButtonUsing the picture quality adjusting buttons Remote controlAdjustment foot Front Lamp cover Adjustment feet Rear Preparating your projector ContinueUsing the remote control Operational range of the remote controlReception angle Setting up the screen Setting up your projectorBasic setup Adjusting the projection angleScreen size and projection distance When the aspect ratio of the screen isViewing video images Connecting the projector to video equipmentBasic home theater system connection PreparationsConnecting to a Video player, etc Connecting to a DVD playerWhen a TV tuner or VCR is connected Plugging in the power cord Connecting to video equipment having a DVI-D terminalViewing video images Preparation Projecting imagesWhen projected images are distorted to a trapezoid To stop projectingCineFocus button How to change the settings Setting the aspect ratioWith the remote control With the Feature menuPlugging the power cord Connecting the projector to a computerViewing computer images For digital connectionEN-19 Example of the setting procedure for external output When connecting to a notebook computerViewing computer images Auto Position buttonMenu operation How to set the menusInstallation menu Available settings in the menusMenu operation Image menuSignal Menu Feature menuTo adjust the brightness Contrast and Brightness Adjusting projected imagesTo adjust the color Color and Tint To sharpen or soften the projected image SharpnessTo adjust the tone of white Color Temp About color temperatureTo enable the stored color temperature Adjusting projected images To adjust the vertical positionLPF Progressive filter Password function Advanced featuresTo enable the password function To cancel the password functionInstallation other device’s remote commands Advanced featuresHow to install How to use the installed functionsDimension Drawings unit mm Asking for installationReplacing the lamp Interval of lamp replacementCleaning of the projector and the ventilation slots MaintenanceCleaning of the lens Reset of the lamp operation timeNo image appears on the screen Problem Solution TroubleshootingImages are not displayed correctly Problem SolutionTroubleshooting Others Problem SolutionTemperature Normal condition IndicatorsAbnormal condition Status ConditionReplacement part Option / Not included in the box SpecificationsDVI-D Hdcp ConnectorsNorth America Mitsubishi Projector Contact Information