Mitsubishi Electronics LVP-XD10U Inserting Batteries in the Remote Control, Main Unit Function

Main Unit	Function
Standby/On	Turns the projection lamp on and off.
Freeze	Pressing this button displays a still (frozen) picture.
Magnify	Pressing this button partially magnifies a displayed picture.
	(Move the picture with the Disk Pad after pressing the Magnify button.)
Disk Pad	When the OSD menu is active, Disk Pad acts as ST selecting device.
	When the on-screen menus are not active, it works as mouse pad.
	When the magnify function is active, use disk pad to move through the
	picture.
Menu	To call the OSD Menu.
	To enter sub-pages.
	To select items.
Blank	The blank screen is displayed by pressing Blank. And the blank
	screen will be revealed partially from top to bottom by pressing Blank
	again.
Source	Selects the input source.
Mute	Mutes the sound.
Volume	Adjusts the volume. The sound gets louder or quieter by pressing the
	"+" or "-" button.
Laser	Laser-pointer-on button. Use as a stick (for indication).
Mouse Left-Click	When operating in the mouse emulation mode, it registers a left
	mouse click.
Mouse Right-	When operating in the mouse emulation mode, it registers a right
Click	mouse click.
Exit	To leave current OSD Pages.
W X Drag	To move Left/Right among OSD items.

Inserting Batteries in the Remote Control

Be sure to follow instructions in placing batteries into the remote control units.

zPush and slide the lid in the direction of the arrow.

zInstall two ‘AAA’ batteries as indicated inside the battery compartment.

zReplace the lid and snap it into place.

Caution

zAvoid excessive heat and humidity.

zDo not mix new and old or different types of batteries.

10English