Mitsubishi Electronics HC4000 Viewing video images, Connecting the projector to video equipment

Page 14

Viewing video images

A. Connecting the projector to video equipment

•When the projector and the connected devices are located too close to each other, the projected image may be affected by their interference.

•See the owner’s guide of each device for details about its connections.

Preparation:

•Make sure that the power of the projector and that of the video equipment are turned off.

Basic home theater system connection

Video player

DVD player

Set-top box or digital tuner

EN-14

Image 14

Contents HC4000 When using the projector in Europe Risk of Electric Shock Do not OpenContents Important safeguards Important safeguards Preparing your projector Inserting the batteries into the remote controlRemoving the batteries from the remote control What’s included in the boxControl panel Preparing your projectorOverview Terminal panelBottom side Remote controlUsing the picture quality adjusting buttons Reception angle Using the remote controlOperational range of the remote control When the aspect ratio of the screen is Setting up your projectorSetting up the screen Screen size and projection distanceWhen the aspect ratio of the image is Setting up your projectorWhen the aspect ratio of the screen is 2.351 CinemaScope With the Installation menu See page 26 for menu setting When fine streaks are seen on projected imagesWhen projected images are distorted to a trapezoid To cancel the menuRear projection InstallationFront projection, ceiling mounting Trigger terminalBasic home theater system connection Connecting the projector to video equipmentViewing video images PreparationWhen a TV tuner or VCR is connected Connecting to a video player, etcConnecting to a DVD player or Hdtv decoder Viewing video imagesConnecting to video equipment having a Hdmi terminal Connection for video equipment having an Hdmi terminalPlugging in the power cord Projecting images To stop projecting Setting the aspect ratio ZOOM1 ZOOM2 Stretch ANAMORPHIC1 ANAMORPHIC2With the Feature menu See page 26 for menu setting How to change the settingsWith the remote control Viewing computer images Connecting the projector to a computerPlugging the power cord About DDCViewing computer images ComputerExample of the setting procedure for external output When connecting to a notebook computerSetting of the resolution Auto Position buttonFeature Signal Keystone Lamp Mode Menu operationSetting Function How to set the menusAvailable settings in the menus Menu operationInstallation menu Feature menu Signal menu User menuAV memory To store the settingsTo enable the stored image quality settings Information menuTo adjust the color Color and Tint Adjusting projected imagesTo adjust the brightness Contrast and Brightness How to Use BrilliantColorTMAbout color temperature Adjusting projected imagesTo adjust the tone of white Color Temp To enable the stored color temperatureBlue Magenta RED How to Use Color ManagementTo adjust the ratio of change in brightness Gamma Mode HighLPF Progressive filter To enable the stored gamma modeTo adjust the vertical position To enable the password function Advanced featuresPassword function To cancel the password functionInterval of lamp replacement Replacing the lampTo replace the lamp When the projector is mounted to the ceilingReplacing the lamp Reset of the lamp operation time Cleaning of the lens MaintenanceCleaning of the projector and the ventilation slots Troubleshooting No image appears on the screen Problem SolutionImages are not displayed correctly TroubleshootingProblem Solution Images are not displayed correctly Problem Solution Others Problem Solution Normal condition IndicatorsPower Status Condition Possible Solution Abnormal conditionSpecifications Dimension drawings unit mmSpecifications Computer IN/COMPONENT Video ConnectorsReplacement part option/not included in the box VLT-HC3800LPMitsubishi Electric Corporation