Viewing video images (continued)
6.Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See page 10.)
•When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 12.)
7.Adjust the image size by turning the zoom ring.
•If necessary, adjust the focus and zoom again.
To stop projecting:
STATUS indicator |
|
POWER indicator | OFF ( ) button |
HC4000
POWER button
8.Press the POWER button on the projector or the OFF (
) button on the remote control.
•A confirmation message is displayed.
•To cancel the procedure, leave the projector for a while or press the MENU button.
9.Press the POWER button on the projector or the OFF (
) button on the remote control again.
•The lamp goes out and the projector goes into a standby mode. In this standby mode, the STATUS indicator blinks green.
10.Wait about 90 seconds.
•During this period of 90 seconds in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.
•The lamp can’t be lit again for 1 minute after turning off the projector for safety purpose. It will take another 1 minute for the STATUS indicator to go out. If you want to turn on the projector again, wait until the indicator goes out, and then press the POWER button.
•The air outlet fans rotate faster as the temperature around the projector rises.
•Do not unplug the power cord while the STATUS indicator is blinking. Unplugging the power cord immediately after use may cause a lamp breakdown.
•Though the fan makes loud sound during cooling, such symptom is not a malfunction.
11.Unplug the power cord from the outlet.
•The POWER indicator will go out.
•If the power cord should be unplugged accidentally while either the air inlet fan or the air outlet fans are operating or the lamp is on, allow the projector to cool down for 10 minutes with the power off. To light the lamp again, press the POWER button. If the lamp doesn’t light up immediately, repeat pressing the POWER button two or three times. If it should still fail to light up, replace the lamp.
•Cover the lens with the lens cap to protect it from dust.