Mitsubishi Electronics NSB1107STTUW manual Click Next on and will appear

Page 13

(2) Click “Next” on Figure 11 and Figure 12 will appear.

Figure 15

ENGLISH

Figure 12

(3) Click “Next” on Figure 12 and Figure 13 will appear.

Figure 13

(4)Click “CD-ROM Drive(C)” , and click “Next”. Figure 14 will appear.

Figure 14

(5)Click “Finish” on Figure 14 and Figure 15 will appear. Click “OK” on Figure 15 to complete Enumeration of Mitsubishi Monitor Function.

You can confirm that Enumeration of Mitsubishi Monitor Function is successfull with the following method.

•Open “Device Manager” tab in “System” property under “Control Panel”. Confirm that “HID-compliant Device” and “USB Human Interface Device” are listed in “Human Interface Device”. If you can’t confirm it, re- enumerate “Mitsubishi Monitor Function” again by following (a) or (b).

(a)Disconnect and connect the USB cable to the up- stream port of the display monitor.

(b)Cycle power of the display monitor off then on.

N O T E

If the mark appears with “HID-Compliant Device” and/or “USB Human Interface Device”, the enumera- tion was unsuccessful. Select “HID-Compliant Device “and/or “USB Human Interface Device marked with mark and click “Remove” and “Refresh”. After that, the enumeration is automatically started.

Generic USB Hub

Figure 16

N O T E

The following should be observed in order to use the USB function reliably:

•Make sure all connections are made firmly and correctly.

•Do not change the Upstream port during the recognition of the monitor or other peripherals.

•Close all Windows program before changing the Upstream port or disconnecting USB cable.

- 13 -

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model NSB1107STTUW Page Contents Declaration of Conformity United States only Radio Interference Regulations STATE- Ment for U.S.AEnergy 2000 Labeling Award Congratulations Why do we have environmentally labelled computers?What does labelling involve? TCO DevelopmentIntroduction FeaturesPower Management Function Internal Preset Memory CapabilityCleaning Your Monitor DDCScreen Position Adjustment Quick Operation ChartUnpacking Tilt/Swivel BaseInput Connector SELECT/OSD OFF Button Power Switch a push-on / push-off switch for AC powerPart Name Control NamesAC Power Connection Installation and ConnectionSignal Cable Connection Connecting to Any IBM VGA Compatible Sys- temSeparate Horizontal and Vertical Sync BNC ConnectionUSB System Basic Application FrontbackInstallation of USB Function Click Next on and will appear Functions How to adjust the screenItems Function AvailableHORIZ-PHASE Color ResetGeometry Reset ContrastMoire Cancel Text ModeMoire Cancel Level Power SaveUSB Port USB UP-STREAMCombination Problem Items to Check Location Picture Black vertical ProblemItems to Check Location This minor condition is caused by grille element overlapSpecifications Appendix Monitor Signal Input Connector DB9-15PMounted on the Rear Panel PIN AssignmentsGroove YouwhencomputertheoffpowertosureBe setthedipswitchesCP871C164A90
Top Page Image Contents