Troubleshooting
The projector does not turn on.
Cause | Remedy | |
|
| |
| Plug the power cord into the AC inlet on the projector, and plug | |
There is no power from the power cable. | the power cord into the power outlet. If the power outlet has a | |
| switch, make sure that it is switched on. | |
|
| |
Attempting to turn the projector on again during | Wait until the cooling down process has completed. | |
the cooling process. | ||
| ||
|
| |
No picture |
|
Cause | Remedy | |
|
| |
The video source is not turned on or connected | Turn the video source on and check that the signal cable is | |
correctly. | connected correctly. | |
|
| |
The projector is not correctly connected to the | Check the connection. | |
input signal device. | ||
| ||
|
| |
The input signal has not been correctly selected. | Select the correct input signal with the SOURCE key on the | |
projector or remote control. | ||
| ||
|
| |
The lens cover is still closed. | Open the lens cover. | |
|
| |
Blurred image |
|
Cause | Remedy |
|
|
The projection lens is not correctly focused. | Adjust the focus of the lens using the focus ring. |
|
|
The projector and the screen are not aligned | Adjust the projection angle and direction as well as the height of |
properly. | the unit if necessary. |
|
|
The lens cover is still closed. | Open the lens cover. |
|
|
Remote control does not work |
|
Cause | Remedy | |
|
| |
The battery is out of power. | Replace the battery with a new one. | |
|
| |
There is an obstacle between the remote control | Remove the obstacle. | |
and the projector. | ||
| ||
|
| |
You are too far away from the projector. | Stand within 8 meters (26 feet) of the projector. | |
|
| |
The password is incorrect |
|
Cause | Remedy | |
|
| |
You do not remember the password. | Please see "Entering the password recall procedure" on page 22 | |
for details. | ||
| ||
|
| |
The LAN function cannot be used |
|
Cause | Remedy | |
|
| |
LAN control settings or LAN cable connection are | Verify the LAN control settings. Please see "Configuring the LAN | |
Control Settings" on page 35 for details. Make sure the LAN | ||
problematic. | ||
cables are properly connected. | ||
| ||
|
| |
The web page is not shown in the web browser or | Reload the page to see the data after changing on the screen. If | |
the page is not showing the modified data, check the IP address | ||
the web page is not responding. | of projector and | |
| ||
|
|
ENGLISH