Microsoft mainboard, K7S5A manual Connecting Case Components, SPK1 Speaker Connector

Page 12

nect all the power cables from the mainboard and then move the jumper cap into the CLEAR setting for a few seconds.

Connecting Case Components

After you have installed the mainboard into a case, you can begin connecting the mainboard components. Refer to the following:

1.Connect the power connector from the power supply to the

ATX_PWR1 connector on the mainboard.

2.Connect the CPU cooling fan cable to

CPUFAN.

3.If there is a cooling fan installed in the system chassis, connect the cable from the cooling fan to the SYSFAN fan power connector on the mainboard.

4.Connect the case switches and indicator LEDs to the FP1 header JP2 for on- board LAN LED.

5.Connect the case speaker cable to SPK1.

SPK1: Speaker Connector

Connect the cable from the PC speaker to the SPK1 header on the m ainboard.

Pin Signal Name

1SPKR

2NC

3Ground

4+5V

JP2: Onboard LAN LED Connections

If you have a set indicator LEDs for the onboard LAN communication, you can connect the LED cable to the header JP2.

Pins 1-2 are for Link LED. Pins 3-4 are for 10/100 Mbps mode LED, the on- board LAN run in 100 Mbps mode when the LED lit.

8

Image 12

Contents Preface CopyrightDeclaration of Conformity Table of Contents Using the Mainboard Software Checklist Introducing the Mainboard IntroductionStandard Items Features SchemeChoosing a Computer Case ROMMainboard Components Installing the Mainboard Safety Precautions Quick GuideInstalling the Mainboard in a Case Checking Jumper SettingsSetting Jumpers Checking Jumper Settings Jumper SettingsConnecting Case Components SPK1 Speaker ConnectorJP2 Onboard LAN LED Connections FPI Connector Installing Hardware Installing the ProcessorBefore installing the Processor CPU Installation ProcedureInstalling Memory Modules Follow these instructions to install the CPUInstallation Procedure DDR Sdram ModuleInstalling a Hard Disk Drive/CD-ROM Installing a Hard Disk DriveAbout IDE Devices About UltraDMAInstalling a Floppy Diskette Drive Installing a CD-ROM/DVD DriveInstalling Add-on Cards Follow these instructions to install an add-on cardConnecting Optional Devices FPAUD1O Front panel MIC/Speaker Out header USB1 Extended USB headerConnecting I/O Devices WOL1 Wake On LANIR1 Infrared port External Connector Color Coding LPT1This concludes . The next chapter covers the Bios Using Bios About the Setup Utility Standard ConfigurationRunning the Setup Utility Using BiosBios Navigation Keys Amibios Simple Setup Utility VersionStandard Cmos Features Date & TimePri Master/Pri Slave/Sec Master/Sec Slave Floppy Drive A/Floppy Drive BAdvanced Setup Password Check Boot to OS/2 64MBSystem Bios Cacheable Timing Setting ModePower Management Setup PCI / Plug and Play Setup Load Optimal Settings Load Best Performance SettingsFeatures Setup Parallel Port Mode Onboard Parallel PortParallel Port IRQ Parallel Port DMACPU PnP Setup CPU Brand/Type/ Core Voltage/Ratio /FrequencyCPU Speed Dram FrequencySystem / CPU Temperature Hardware MonitorVoltage Measurements & FAN Speeds Change Password Change or Remove the PasswordExit Using the Mainboard Software About the Software CD-ROM Auto-installing under WindowsSetup Tab Application TabRead Me Tab Running Setup Manual Installation Utility Software Reference AMI Flash Memory UtilityWinFlash Utility MediaRing Talk Telephony SoftwareRecovery Genius CD GhostLanguage Genius PageABC