Microsoft K7S5A Installing Add-on Cards, Follow these instructions to install an add-on card

Page 19

configure the floppy diskette drives that you have installed.

Installing Add-on Cards

This mainboard has five 32-bit PCI (Peripheral Components Interconnect) expansion slots, one 4xAGP slot, and one AMR slot.

4xAGP Slot The 4xAGP slot is used to install a graphics adapter that supports the 4xAGP specifications and has a 4xAGP edge connector.

PCI Slots PCI slots are used to install expansion cards that have the 32-bit PCI interface.

AMR Slot The AMR (Audio Modem Riser) slot is an industry standard slot that allows for the installation of a special audio/modem riser card. Differ- ent territories have different regulations regarding the specifications of a modem card. You can purchase an AMR card that is approved in your area and install it directly into the AMR slot.

Note: Before installing an add-on card, check the documentation for the card carefully. If the card is not Plug and Play, you may have to manually con- figure the card before installation.

Follow these instructions to install an add-on card:

1.Remove a blanking plate from the system case corresponding to the slot you are going to use.

15

Image 19

Contents Copyright PrefaceDeclaration of Conformity Table of Contents Using the Mainboard Software Introducing the Mainboard Introduction ChecklistStandard Items Scheme FeaturesROM Choosing a Computer CaseMainboard Components Quick Guide Installing the Mainboard Safety PrecautionsChecking Jumper Settings Installing the Mainboard in a CaseSetting Jumpers Jumper Settings Checking Jumper SettingsSPK1 Speaker Connector Connecting Case ComponentsJP2 Onboard LAN LED Connections FPI Connector CPU Installation Procedure Installing HardwareInstalling the Processor Before installing the ProcessorFollow these instructions to install the CPU Installing Memory ModulesDDR Sdram Module Installation ProcedureAbout UltraDMA Installing a Hard Disk Drive/CD-ROMInstalling a Hard Disk Drive About IDE DevicesInstalling a CD-ROM/DVD Drive Installing a Floppy Diskette DriveFollow these instructions to install an add-on card Installing Add-on CardsConnecting Optional Devices USB1 Extended USB header FPAUD1O Front panel MIC/Speaker Out headerWOL1 Wake On LAN Connecting I/O DevicesIR1 Infrared port LPT1 External Connector Color CodingThis concludes . The next chapter covers the Bios Standard Configuration Using Bios About the Setup UtilityAmibios Simple Setup Utility Version Running the Setup UtilityUsing Bios Bios Navigation KeysFloppy Drive A/Floppy Drive B Standard Cmos FeaturesDate & Time Pri Master/Pri Slave/Sec Master/Sec SlaveAdvanced Setup Timing Setting Mode Password CheckBoot to OS/2 64MB System Bios CacheablePower Management Setup PCI / Plug and Play Setup Load Best Performance Settings Load Optimal SettingsFeatures Setup Parallel Port DMA Parallel Port ModeOnboard Parallel Port Parallel Port IRQDram Frequency CPU PnP SetupCPU Brand/Type/ Core Voltage/Ratio /Frequency CPU SpeedHardware Monitor System / CPU TemperatureVoltage Measurements & FAN Speeds Change or Remove the Password Change PasswordExit Auto-installing under Windows Using the Mainboard Software About the Software CD-ROMApplication Tab Setup TabRead Me Tab Running Setup Manual Installation MediaRing Talk Telephony Software Utility Software ReferenceAMI Flash Memory Utility WinFlash UtilityPageABC Recovery GeniusCD Ghost Language Genius