Polaroid 45 Ultra quick start Film Adapters

Page 22

The 120 Film Adapters (Page 11)

Steps 3 and 4 on pages 11 and 12 have changed to the following:

3Orient the 120 film adapter with the correct side up and the notches (a) on the left. Place the unmounted film over the opening so the image is right-reading and the top of the image is at the top of the adapter.

a

4Secure the film by placing the two magnets provided on the top and bottom edges. The magnets must not extend over the depressed channel surrounding the film placement area.

English 5

Inserting the Carrier Into the Scanner (Page 14)

Step 2 has the following note added:

Note: When inserting the 4x5 film carrier, make sure the words "LOCK" and "UNLOCK" face upward. For the four-slide carrier, the words "THIS SIDE UP" face upward.

© 2000 Polaroid Corporation, Cambridge, MA 02139 USA. "Polaroid", "PolaColor" and "SprintScan" are trademarks of Polaroid Corporation. All other product names may be trademarks of their respective owners. All rights reserved.

PL-000000-0

Page 21 Page 22
Image 22
Page 21 Page 22
Contents Installation Quickstart Macintosh Systems System RequirementsPC Systems Unpack the Box Install the Software Position the ScannerComputer Connect the Scanner toSet the Scanner Scsi Address Connect the Scsi Cables Set Termination Connect the Scanner to AC Power and Turn On Power switch Power connectorFour-Slide Film Carrier Loading the Film Carriers4x5 Carrier for 4x5 film 120 Film Adapters For 2 1/4 x 21/4 and 2 1/4 x 2 3/4 in. film Single-35mm Carrier English Insert the Carrier into the Scanner Preview an Image Enhance and Scan the Image Remove the CarrierInstalling a Scsi Host Adapter Limited Warranty Radio and Television Interference FCC Notice U.S.AInstallation Quickstart Errata SprintScan 45 Ultra About This Document Unpack the Box 120 Film Adapters
Top Page Image Contents