Replacing the lamp (continued)
To replace the lamp:
| 1. | Reverse the projector gently. |
| 2. | Loosen the screw (a) using a Phillips screwdriver (+), and |
(b) | (a) | remove the lamp cover (b). |
| ||
| 3. | Loosen the screws (c) using a Phillips screwdriver (+). |
4. Pull up the handle.
5. Pull out the lamp box by the handle while holding the
(c)projector.
(c)
Important:
• Pull the lamp box out of the projector slowly. If it is pulled out quickly, the lamp may break scattering glass fragments.
• Do not spill liquid on the removed lamp box or do not place it near any flammable object or where children can reach to prevent injury or fire.
6.Load a new lamp box securely into the projector in the right orientation.
7.Put the handle back to the original position.
• Make sure that the handle is locked.
8.Tighten up the screws (c) using a Phillips screwdriver (+).
9. Tighten up the screw (a) using a Phillips screwdriver (+) to secure the lamp cover.
Reset of the lamp operation time
Plug in the power cord and reset the lamp operation time by holding down the , , and POWER buttons on the control panel at the same time about three seconds.
•Unless these three buttons are pressed at the same time, the lamp operation time isn’t reset.
•Make sure that the STATUS indicator blinks twice and the lamp operation time is reset successfully.
•The projector doesn’t turn on if the lamp cover isn’t attached securely.
•Be sure to reset the lamp operation time whenever you replace the lamp.
•Do not reset the lamp operation time unless you replace the lamp.
•The lamp is fragile. If it is broken, be careful not to cut yourself with glass fragments.
•Contact your dealer for a new lamp.
•This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the lamp may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. (For the U.S. only.)
Maintenance
Warning:
Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols when cleaning the projector body and lens. Flammable substances may ignite causing fire or breakdown while the lamp is illuminating.
Caution:
Be sure to turn off the lamp and unplug the power cord from the wall outlet before you perform any maintenance on the projector.
Cleaning of the projector and the ventilation slots
Use a soft cloth to clean the projector and the ventilation grilles. When the grilles become dirty, wipe them with a soft cloth dampened with diluted mild detergent, and then wipe them with a dry cloth.
To protect the surface of the projector from fading or deteriorating:
•Do not spray insecticide on or inside the projector.
•Do not use benzine or thinner to clean it.
•Do not let rubber or plastic materials contact with projector.
Cleaning of the lens
Use a standard