Planar SD2420W manual Product Use, Operating in 2D mode, User controls and OSD menu

Page 15
Controls and LED indicator

Product Use

 

Operating in 2D mode

 

Your SD2420W unit can operate either as a

 

3D stereoscopic monitor or in the standard

 

2D mode. Converting to 2D viewing can be

 

accomplished by either turning off the power

 

to one of the monitors or by putting the

 

mirror into the locked upright position. To

 

move the mirror to the raised position, use

 

two hands to slide it up the mirror support

 

arms and then raise it until it drops into the

 

locked position. To lower the mirror, use two

 

hands to lift it out of the locked slot and then

 

lower it down onto the fine adjustment

 

screws.

StereoMirror in 2D mode

 

The mirror should not be forced down. This can break the glass and damage the mirror frame. The mirror must be pulled forward before lowering.

User controls and OSD menu

The two monitors have a power switch on the right side of the bottom bezel. The switch has a dual function: the control for turning the monitor on or off and the LED indicator of monitor power status. When the LED is green, the power is on. When the LED is amber, the monitor is in power-saving mode.

The Source button allows the user to select VGA or DVI input. The Menu (M), Auto Adjust (AUTO), left arrow (<), and right arrow (>) buttons can be used to control the

On-Screen Display (OSD) menu. Press the Menu button to access the OSD menu, make a selection among the main menus, or confirm functions. The left arrow button adjusts the brightness or functions within the OSD menu. The right arrow button adjusts the contrast or functions within the OSD menu. The Auto Adjust button serves as an exit key to return to the previous OSD menu.

User’s Guide 9

Image 15
Contents SD2420W Planar Systems, Inc NW Compton Drive Beaverton, or Don’t Usage NoticeBox Contents Two DVI cables 6-ft and 12-ft Contents Complex data analysis Stereoscopic ViewingStereoMirror Technology Defined the 3D Assemble the unit Getting StartedUser’s Guide Select a graphics card Install the mirror-flip PCI cardConnect the cables Check the alignment Connect the power cordsOperating in 2D mode Product UseUser controls and OSD menu Power management Monitor Specifications DisplaysVideo Size and weight Plug and PlayEnvironment Accessories System CareSoftware Compatibility Problem Possible Solution TroubleshootingProduct Registration WarrantyImportant Recycle Instructions CRT RecyclingPlanar Customer Service Mailplanarsupport@planar.com