Planar SD2420W manual Connect the cables

Page 13

Connect the cables

The SD2420W unit comes with one 6-foot DVI cable, one 12-foot DVI cable, and one 14-inch DVI cable.

1.

Plug one end of the 6-foot DVI

 

 

cable into the primary port of

 

 

the dual-channel DVI graphics

 

 

card. Plug the other end into

 

 

the bottom monitor of the

 

 

SD2420W unit.

 

2.

Plug one end of the 14-inch DVI

 

 

cable into the secondary output

 

 

of the dual-channel graphics

 

 

card. Plug the other end into

 

 

the input port (labeled “IN”) of

 

 

the mirror-flip PCI card.

 

3.

Plug one end of the 12-foot DVI cable

Short DVI cable installed

 

into the output port of the mirror-flip

 

 

PCI card (labeled “OUT”). Plug the

 

other end into the top monitor of the SD2420W unit.

The two monitors must be connected with an off-the-shelf video cable to comply with FCC regulations. Ferrite-core interface cables are provided. This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

User’s Guide 7

Image 13
Contents SD2420W Planar Systems, Inc NW Compton Drive Beaverton, or Don’t Usage NoticeBox Contents Two DVI cables 6-ft and 12-ft Contents Complex data analysis Stereoscopic ViewingStereoMirror Technology Defined the 3D Assemble the unit Getting StartedUser’s Guide Select a graphics card Install the mirror-flip PCI cardConnect the cables Check the alignment Connect the power cordsProduct Use Operating in 2D modeUser controls and OSD menu Power management Displays Monitor SpecificationsVideo Plug and Play Size and weightEnvironment System Care AccessoriesSoftware Compatibility Problem Possible Solution TroubleshootingProduct Registration WarrantyImportant Recycle Instructions CRT RecyclingPlanar Customer Service Mailplanarsupport@planar.com