Planar PX2211MW manual Preface, FCC Statement Warning, Canadian DOC Notice

Page 3
Preface

Preface

This manual is designed to assist users in setting up and using the LCD Monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer.

FCC Statement Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reposition or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced monitor technician for help.

Warning

Use only shielded signal cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for comliance could void your authority to operate the equipment.

This device complies with part 15 FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.

Canadian DOC Notice

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

2

Image 3
Contents Page Troubleshooting ContentsContents InstallationPreface FCC Statement WarningCanadian DOC Notice Important Safety Instructions Important Recycle InstructionContains Mercury, Dispose of Properly Unpacking InstallationDetaching LCD Monitor from Its Stand Connecting the LCD Monitor and BaseOptional Mounting Alternatives Tilt, Swivel and Pivot RotationConnecting the USB up Stream Cable Connecting the DisplayConnecting the AC Power Connecting the Audio Cable1. Make sure the AC power cord is connected to the LCD Monitor Connecting the USB Down StreamSetting Up the LCD Monitor Power Management SystemAuto/Exit Display ControlsUser Controls Menu/EnterAdjusting the Monitors Display DescriptionMain OSD 720/640x400 Auto AdjustmentTurn Off LanguageDescription OSD Lock Out FunctionIcon FunctionVideo SpecificationsTechnical Information LCD PanelPlug & Play Power ManagementPower Supply AC Input Size and WeightStandard Timing Table FH KHz Troubleshooting Technical Support Cables, Replacement Lamps, AccessoriesProduct Registration and Technical Support Register Your Planar Products Today