Interface for Arm Applications

The rear of this LCD display has four integrated 4 mm, 0.7 pitch threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997). Note: Please using M 4mm x 16mm (L) screw for this application.

Connecting the Display

1.Power off your computer.

2.Connect one end of the signal cable to the LCD Monitor’s VGA port or HDMI port. (See Fig 1-5)

3.Connect the other end of the signal cable to the VGA port, DVI port or HDMI port on your PC or video source: (DVD players, game consoles, set top boxes…etc)

4.Make sure connections are secure.

Note: HDMI to HDMI cable is not supplied.

Figure 1-4

HDMI D-SUB

Figure1-5

Connecting the AC Power

5. Connect the power cord to the LCD Monitor.(See Fig. 1-6)

6. Connect the power cord to an AC power source.

Power Jack

Power Cord

Figure1-6

Connecting the Audio Cable

1.Connect the audio cable to the "LINE OUT" jack on your PC's audio card or to the front panel's “AUDIO OUT” jack of your CD

ROM drive. (See Fig. 1-7)
Connect the other end of the audio cable to the LCD Monitor's
"LINE IN" jack.
Note: If a HDMI to HDMI cable (not supplied) is connected, the	Audio Jack
audio cable is not required. A HDMI to HDMI cable will carry both	Figure1-7

audio/video signals.

Connecting the USB up Stream Cable

1.Connect the USB UP Stream Cable to the LCD Monitor.

(See Fig. 1-8)

USB UP Stream

Figure1-8