Connecting an Antenna or Cable TV
aAntenna:
Disconnect the antenna from the rear of the TV and identify the antenna cable. If it is a round 75 ohm coaxial cable connect it directly to the jack marked ANT. IN on your Recorder. If your antenna cable is flat connect it to a
adaptor (not supplied) and slip the adaptor over the ANT. IN jack. Don’t attempt to screw it into to the Recorder.
bCable TV:
If your cable connection has no converter or descrambler, unscrew the cable from your TV and attach it to the ANT. IN jack on the Recorder.
If a converter is required connect a coaxial cable from the wall jack to the IN connector on the converter, and a coaxial cable from the OUT connector on the converter to the ANT. IN on your Recorder. This cable hookup permits both TV and Recorder operation.
To view or record a CATV channel
1.Tune the TV to the Recorder output channel (CH 3 or 4).
2.Set the Recorder channel selector to the cable output channel. (Example: CH3)
3.Select a channel using the cable converter.
Notes:
•With this connection, you cannot record one channel while viewing another.
•If you are using a cable box to tune channels, it is not necessary to do Auto Channel Set.
a | Antenna | Antenna |
|
| Cable TV |
|
| Wall Jack |
| Flat Wire |
|
| (300 ohm) |
|
| 300/75 ohm OR | OR |
| Adapter |
|
| (Not supplied) |
|
Rear of the recorder
b 
Cable TV
Back Panel of Wall Jack
Typical Cable Box
12
