Connections to Your TV

Make one of the following connections, depending on the capabilities of your existing equipment.

Tips

Depending on your TV and other equipment you wish to connect, there are various ways you could connect the recorder. Use only one of the connections described below.

Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

Caution

Make sure the recorder is connected directly to the TV. Tune the TV to the correct video input channel.

Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

Do not connect your recorder via your VCR. The DVD image could be distorted by the copy protection system.

RF coaxial connection

Connect the RF OUT jack on the Recorder to the antenna in jack on the TV using the supplied 75-ohm Coaxial Cable (R).

How to set the Recorder’s RF output channel

1.When the Recorder is turned off, press and hold CH (V/v) on the front panel for more than five seconds. [ch03] or [ch04] appears in the display window.

2.Press CH (V/v) to change the RF output channel (ch03 or ch04).

3.Tune the TV to this channel.

Video connection

Connect the VIDEO OUT jack on the recorder to the video in jack on the TV using the video cable (V).

Audio (Left/Right) Connection

Connect the left and right AUDIO OUT jacks of the recorder to the audio left and right IN jacks on the TV using the audio cables (A). Do not connect the recorder’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

S-Video connection

Connect the S-VIDEO OUT jack on the recorder to the S-Video in jack on the TV using the S-Video cable (S).

Component Video connection

Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the recorder to the corresponding input jacks on the TV using an Y Pb Pr cable (C).

If your television is a high-definition or “digital ready” television, you may take advantage of the recorder’s progressive scan output for higher video resolution. If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on the recorder.

Set the resolution to 480p using RESOLUTION button for progressive signal.

Note:

Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack) or S-VIDEO connection.

Caution

If the resolution is set to 720p or 1080i, the VIDEO OUT, S-VIDEO OUT and COMPONENT VIDEO OUT connections are not available.

Rear of TV

ANTENNA

S-VIDEO

 

 

 

 

 

INPUT

INPUT

 

 

VIDEO

AUDIO INPUT

 

COMPONENT VIDEO INPUT

INPUT

 

 

 

Y

Pb

Pr

 

L

R

R

 

S

 

C

 

V

 

A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Rear of the recorder

Hookup and Settings

13

Page 13
Image 13
LG Electronics DR1F9H Connections to Your TV, RF coaxial connection, Video connection, Audio Left/Right Connection