Onkyo TX-SR804E Precautions, Memory Backup, For British models, For European Models, Power

Page 3
Precautions

TX-SR804/804E_En.book Page 3 Monday, September 4, 2006 9:34 AM

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal with- out the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user- serviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild deter- gent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thin- ners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel let- tering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SEC- TION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

Some models have a voltage selector switch for compatibility with power systems around the world. Before you plug in such a model, make sure that the voltage selector is set to the correct voltage for your area.

Memory Backup

The AV receiver uses a battery-less memory backup system in order to retain radio presets and other settings when it’s unplugged or in the case of a power failure. Although no batteries are required, the AV receiver must be plugged into an AC outlet in order to charge the backup system. Once it has been charged, the AV receiver will retain the settings for several weeks, although this depends on the environment and will be shorter in humid climates.

For British models

Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured mark- ings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

For North American & Australian models

Setting the [STANDBY/ON] switch to STANDBY does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Never Touch this Unit with Wet Hands—Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

6.Handling Notes

If you need to transport this unit, use the original packaging to pack it how it was when you origi- nally bought it.

Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

This unit’s top and rear panels may get warm after prolonged use. This is normal.

If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

IMPORTANT

The plug is fitted with an appropriate fuse. If the fuse needs to be replaced, the replacement fuse must approved by ASTA or BSI to BS1362 and have the same ampere rating as that indicated on the plug. Check for the ASTA mark or the BSI mark on the body of the fuse. If the power cord’s plug is not suitable for your socket outlets, cut it off and fit a suitable plug. Fit a suitable fuse in the plug.

For European Models

Declaration of Conformity

We, ONKYO EUROPE ELECTRONICS GmbH

LIEGNITZERSTRASSE 6, 82194 GROEBENZELL, GERMANY

declare in own responsibility, that the ONKYO product described in this instruction manual is in compliance with the corresponding technical standards such as EN60065, EN55013, EN55020 and EN61000-3-2, -3-3.

GROEBENZELL, GERMANY

K. MIYAGI

ONKYO EUROPE ELECTRONICS GmbH

3

Image 3
Contents AV Receiver ContentsTX-SR804 TX-SR804E Instruction ManualAVIS Important Safety InstructionsFor European Models PrecautionsMemory Backup For British modelsFor Canadian Models Supplied AccessoriesPrecautions—Continued For U.S. modelsAudio/Video FeaturesAmplifier ProcessingMultiroom Capability Main RoomZone 2 Sub Room Connection ContentsTurning On & First Time Setup IntroductionFront Panel Getting to Know the AV ReceiverGetting to Know the AV Receiver—Continued K L M N O P QRS T U V WOn European Model 3Listening mode and format indicators Display1MUTING indicator 2ZONE 2 indicatorGetting to Know the AV Receiver—Continued Rear PanelNRS232 Getting to Know the AV Receiver—ContinuedNotes Remote ControllerInstalling the Batteries Using the Remote ControllerRemote Controller—Continued About the Remote Controller ModesRECEIVER/TAPE Mode ASTANDBY button Remote Controller—ContinuedRemote Controller—Continued DVD ModeRemote Controller-Continued CD, MD, and CDR ModesRemote Controller—Continued HDD ModeCenter speaker Connecting Your SpeakersEnjoying Home Theater Front left and right speakersUsing Dipole Speakers Connecting Your Speakers—ContinuedConnecting Your Speakers Connecting a Powered SubwooferSpeaker Connection Precautions Connecting the Speaker CablesConnecting Your Speakers—Continued Connecting Antenna Connecting the Indoor FM AntennaConnecting the AM Loop Antenna Notes Connecting Antenna—ContinuedConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaAV Connection Color Coding Connecting Your ComponentsAbout AV Connections Optical Digital JacksAudio Connection Formats Connecting Your Components—ContinuedWhich Connections Should I Use? Video Connection FormatsHint Connecting a TV or ProjectorC B a Connecting Your Components—Continuedor the other Connecting a DVD playerConnecting Your Components—Continued C B aConnecting Your Components—Continued Hooking Up the Multichannel DVD Input7.1 ch 5.1 chHint Connecting a VCR or DVD Recorder for PlaybackConnecting Your Components—Continued C B aConnecting Your Components—Continued Connecting a VCR or DVD Recorder for RecordingSatellite, cable, set-topbox, etc Connecting Your Components—ContinuedC B a HintAbout Copyright Protection Connecting Components with HDMIAbout HDMI Supported Audio FormatsAudio Signal Flow Chart Making HDMI ConnectionsConnecting Your Components—Continued Video Signal Flow ChartS-Videooutput Connecting Your Components—ContinuedSignal flow VIDEO 4 INPUT S VIDEOConnecting Your Components—Continued Connecting a CD PlayerConnecting a Turntable a INConnecting Your Components—Continued Connecting a Power AmplifierFor HDD-compatiblecomponents that Connecting an HDD-compatibleComponentConnecting the Power Cords of Other Components Connecting Your Components—ContinuedNotes Connecting Onkyo ComponentsConnecting the Power Cord Connecting Your Components—ContinuedTurning On the AV Receiver Turning On and StandbySmooth Operation in a Few Easy Steps AV receiver is connected First Time SetupAutomatic Speaker Setup NotesCheck the Results First Time Setup—ContinuedCancel Apply the ResultsUsing a Powered Subwoofer First Time Setup—ContinuedDistance Error Changing the Speaker Settings ManuallyHDMI Video Setup First Time Setup—ContinuedSetup closes Setup closes Component Video SetupFirst Time Setup-Continued Press the SETUP buttonSetup closes Digital Audio Input SetupFirst Time Setup—Continued Press the SETUP buttonSetup closes Changing the Input DisplayMinimum Speaker Impedance First Time Setup—ContinuedSetup closes TV Format Setup not North American modelsAM Frequency Step Setup on some models First Time Setup—ContinuedBasic AV Receiver Operation Playing Your AV ComponentsDisplaying AM/FM Radio Information Tuning into AM/FM Radio StationsListening to the Radio Listening to AM/FM StationsNotes Using RDS European Model OnlyListening to the Radio—Continued RDS Program Types PTYListening to the Radio—Continued Displaying Radio Text RTListening to Traffic News TP Finding Stations by Type PTYListening to the Radio—Continued Setting the Satellite Radio ModeNorth American Models Only Listening to XM Satellite RadioListening to the Radio—Continued Connecting the XM Mini-Tunerand Home DockSigning Up for XM Satellite Radio Selecting XM Satellite Radiobuttons to select a category Selecting XM Radio ChannelsListening to the Radio—Continued You can also use the Left and RightSetup closes Displaying XM Radio InformationPositioning the XM Antenna 1.Channel name 2.Channel number & Preset numberThe MEMORY indicator appears and Presetting AM, FM, and XM StationsSelecting Presets Deleting PresetsInput Channel Using the Multichannel DVD InputMultichannel DVD Input Settings Using the Multichannel DVD InputMuting the AV Receiver Adjusting Speaker LevelsSetting the Display Brightness Common FunctionsDisplaying Source Information Using the Sleep TimerUsing Headphones Common Functions—ContinuedSelecting on the AV Receiver Using the Listening ModesSelecting with the Remote Controller Selecting the Listening ModesUsing the Listening Modes—Continued Using the Listening Modes—Continued About the Listening ModesUsing the Listening Modes—Continued Onkyo Original DSP ModesNotes RecordingRecording the Input Source Recording Audio and Video from Separate SourcesAbout the Onscreen Setup Menus Onscreen Setup MenusThe menu for the selected setting Adjusting the Listening ModesAudio Adjust Menu Using the Re-EQFunctionNeo:6 Music Adjusting the Listening Modes—ContinuedTone Control Settings PL IIx and Neo:6 Settings PL IIx Music 2 ch onlyMultiplex Dolby Digital SettingsMono/Multiplex Settings Mono LFE Level SettingWhen you’ve finished, press the Default Listening ModesAdjusting the Listening Modes—Continued SETUP buttonSpeaker Configuration Advanced SetupSpeaker Setup The Speaker Setup menu appearsSetup closes Advanced Setup—ContinuedLow-PassFilter for the LFE Channel Subwoofer ModeSetup closes Speaker DistanceAdvanced Setup—Continued The Speaker Setup menu appearsThe Speaker Setup menu appears Speaker Level CalibrationAdvanced Setup-Continued lute volume setting 82. If you normally listen at0–1ft 0–0.3m Default: Select this THX Audio SetupAdvanced Setup—Continued The Speaker Setup menu appearsThe Equalizer Settings menu appears Equalizer SettingsAdvanced Setup—Continued The Speaker Setup menu appearsTo name an AM or FM radio preset Input SetupCharacter Edit Advanced Setup-ContinuedAdvanced Setup—Continued IntelliVolumeVolume Setup PreferencesOSD Position OSD SetupHDMI Setup Lock SetupAdvanced Setup—Continued Changing the Remote Controller’s IDRemote IDs Changing the AV Receiver’s Remote IDPress the SETUP button Digital Input Signal FormatsAdvanced Setup—Continued SETUP buttonAdvanced Setup-Continued Correcting Sound and Picture SyncZone Connecting ZoneUsing an Amp in Zone Using Only Speakers in ZoneControlling Zone 2 from the AV receiver Powered Zone 2 SettingUsing Zone Zone 2—ContinuedTo Mute Zone Controlling Zone 2 with the Remote ControllerAdjusting the Volume for Zone Zone 2—ContinuedZone 2-Continued Using a Multiroom Kit with a CabinetUsing a Multiroom Kit with Zone Using a Multiroom Kit with Other ComponentsThe Remote indicator flashes twice Entering Remote Control CodesControlling Other Components remote control codeThe Remote indicator flashes five Resetting the Remote ControllerResetting the REMOTE MODE Buttons Controlling Other Components—Continuedremote controller mode Cancels functionsCancels functions Adjust the TV’s volumeLearning Commands from Other Remote Controllers the Remote indicator flashes twiceControlling Other Components—Continued Deleting Macros Using MacrosMaking Macros Running MacrosTroubleshooting PowerAudio Video Troubleshooting—ContinuedOthers Remote ControllerTuner RecordingTroubleshooting—Continued Video Section SpecificationAmplifier Section GeneralONKYO EUROPE UK Office 2 9 3 4 4 3ONKYO U.S.A. CORPORATION ONKYO EUROPE ELECTRONICS GmbH