Onkyo TX-SR804E instruction manual Speaker Level Calibration, Advanced Setup-Continued, Notes

Page 73
Speaker Level Calibration

TX-SR804/804E_En.book Page 73 Monday, September 4, 2006 9:34 AM

Advanced Setup—Continued

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 40).

With these settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listening position.

Notes:

• The speakers cannot be calibrated while the output of

the AV receiver is muted or a pair of headphones is

connected.

• Because the AV receiver supports THX, the test

tone is output at the standard level of 0 dB (abso-

lute volume setting 82). If you normally listen at

volume settings below this, be careful because the

3

ENTER

ENTER

Use the Up and Down [• Because the AV receiver supports THX, the test]/[ ] buttons to select “Level Calibra- tion,” and then press [ENTER].

The Level Calibration menu appears and the pink noise test tone is output by the front left speaker.

3-4.Level Calibration

------------------------

a.Left

:

0dB

b.Center

:

0dB

c.Right

:

0dB

d.Surround R

:

0dB

e.SurrBack R

:

0dB

f.SurrBack L

:

0dB

g.Surround L

:

0dB

h.Subwoofer

:

0dB

test tone will be much louder.

1

RECEIVER

Press the [RECEIVER] REMOTE

MODE button, followed by the

 

 

[SETUP] button.

The main menu appears onscreen.

2

 

Use the Up and Down [ ]/[ ]

 

 

 

 

buttons to select “3. Speaker

 

 

Setup,” and then press [ENTER].

 

ENTER

The Speaker Setup menu appears.

 

 

ENTER

Note:

Speakers that you set to No or None on the Speaker Config menu (page 70) cannot be adjusted.

4

Use the Up and Down [ ]/[ ]

 

 

buttons to select each speaker,

 

and use the Left and Right

 

ENTER

 

[ ]/[ ] buttons to set the vol-

 

ume.

 

The level can be adjusted from –12 to

 

+12 dB in 1 dB steps (–15 to +12 dB

 

for the subwoofer).

5

Repeat step 4 so that the volume

 

 

of the test tone from each

 

speaker is the same.

 

If you’re using a handheld sound level

 

meter, adjust the level of each speaker

 

so it reads 75 dB SPL at the listening

 

position, measured with C-weighting

 

and slow reading.

6

Press the [SETUP] button.

 

 

Setup closes.

Note:

•The speaker levels can also be changed by using the dedicated buttons on the remote controller. Press the [TEST TONE] button to output the test tone. Use the [CH SEL] button to select each speaker, and use the [LEVEL–] and [LEVEL+] buttons to adjust the level.

73

Page 72 Page 74
Image 73
Page 72 Page 74
Contents TX-SR804 TX-SR804E ContentsInstruction Manual AV ReceiverAVIS Important Safety InstructionsMemory Backup PrecautionsFor British models For European ModelsPrecautions—Continued Supplied AccessoriesFor U.S. models For Canadian ModelsAmplifier FeaturesProcessing Audio/VideoMain Room Multiroom CapabilityZone 2 Sub Room Turning On & First Time Setup ContentsIntroduction ConnectionFront Panel Getting to Know the AV ReceiverK L M N O P QRS T U V W Getting to Know the AV Receiver—ContinuedOn European Model 1MUTING indicator Display2ZONE 2 indicator 3Listening mode and format indicatorsGetting to Know the AV Receiver—Continued Rear PanelNRS232 Getting to Know the AV Receiver—ContinuedInstalling the Batteries Remote ControllerUsing the Remote Controller NotesAbout the Remote Controller Modes Remote Controller—ContinuedRECEIVER/TAPE Mode ASTANDBY button Remote Controller—ContinuedRemote Controller—Continued DVD ModeRemote Controller-Continued CD, MD, and CDR ModesRemote Controller—Continued HDD ModeEnjoying Home Theater Connecting Your SpeakersFront left and right speakers Center speakerConnecting Your Speakers Connecting Your Speakers—ContinuedConnecting a Powered Subwoofer Using Dipole SpeakersConnecting the Speaker Cables Speaker Connection PrecautionsConnecting Your Speakers—Continued Connecting the Indoor FM Antenna Connecting AntennaConnecting the AM Loop Antenna Connecting an Outdoor FM Antenna Connecting Antenna—ContinuedConnecting an Outdoor AM Antenna NotesAbout AV Connections Connecting Your ComponentsOptical Digital Jacks AV Connection Color CodingWhich Connections Should I Use? Connecting Your Components—ContinuedVideo Connection Formats Audio Connection FormatsC B a Connecting a TV or ProjectorConnecting Your Components—Continued HintConnecting Your Components—Continued Connecting a DVD playerC B a or the other7.1 ch Hooking Up the Multichannel DVD Input5.1 ch Connecting Your Components—ContinuedConnecting Your Components—Continued Connecting a VCR or DVD Recorder for PlaybackC B a HintConnecting Your Components—Continued Connecting a VCR or DVD Recorder for RecordingC B a Connecting Your Components—ContinuedHint Satellite, cable, set-topbox, etcAbout HDMI Connecting Components with HDMISupported Audio Formats About Copyright ProtectionConnecting Your Components—Continued Making HDMI ConnectionsVideo Signal Flow Chart Audio Signal Flow ChartSignal flow Connecting Your Components—ContinuedVIDEO 4 INPUT S VIDEO S-VideooutputConnecting a Turntable Connecting a CD Playera IN Connecting Your Components—ContinuedConnecting Your Components—Continued Connecting a Power AmplifierConnecting the Power Cords of Other Components Connecting an HDD-compatibleComponentConnecting Your Components—Continued For HDD-compatiblecomponents thatConnecting the Power Cord Connecting Onkyo ComponentsConnecting Your Components—Continued NotesTurning On and Standby Turning On the AV ReceiverSmooth Operation in a Few Easy Steps Automatic Speaker Setup First Time SetupNotes AV receiver is connectedCancel First Time Setup—ContinuedApply the Results Check the ResultsDistance Error First Time Setup—ContinuedChanging the Speaker Settings Manually Using a Powered SubwooferFirst Time Setup—Continued HDMI Video SetupSetup closes First Time Setup-Continued Component Video SetupPress the SETUP button Setup closesFirst Time Setup—Continued Digital Audio Input SetupPress the SETUP button Setup closesMinimum Speaker Impedance Changing the Input DisplayFirst Time Setup—Continued Setup closesAM Frequency Step Setup on some models TV Format Setup not North American modelsFirst Time Setup—Continued Setup closesBasic AV Receiver Operation Playing Your AV ComponentsListening to the Radio Tuning into AM/FM Radio StationsListening to AM/FM Stations Displaying AM/FM Radio InformationListening to the Radio—Continued Using RDS European Model OnlyRDS Program Types PTY NotesListening to Traffic News TP Displaying Radio Text RTFinding Stations by Type PTY Listening to the Radio—ContinuedNorth American Models Only Setting the Satellite Radio ModeListening to XM Satellite Radio Listening to the Radio—ContinuedSigning Up for XM Satellite Radio Connecting the XM Mini-Tunerand Home DockSelecting XM Satellite Radio Listening to the Radio—ContinuedListening to the Radio—Continued Selecting XM Radio ChannelsYou can also use the Left and Right buttons to select a categoryPositioning the XM Antenna Displaying XM Radio Information1.Channel name 2.Channel number & Preset number Setup closesSelecting Presets Presetting AM, FM, and XM StationsDeleting Presets The MEMORY indicator appears andMultichannel DVD Input Settings Using the Multichannel DVD InputUsing the Multichannel DVD Input Input ChannelSetting the Display Brightness Adjusting Speaker LevelsCommon Functions Muting the AV ReceiverUsing Headphones Using the Sleep TimerCommon Functions—Continued Displaying Source InformationSelecting with the Remote Controller Using the Listening ModesSelecting the Listening Modes Selecting on the AV ReceiverUsing the Listening Modes—Continued Using the Listening Modes—Continued About the Listening ModesUsing the Listening Modes—Continued Onkyo Original DSP ModesRecording the Input Source RecordingRecording Audio and Video from Separate Sources NotesAbout the Onscreen Setup Menus Onscreen Setup MenusAudio Adjust Menu Adjusting the Listening ModesUsing the Re-EQFunction The menu for the selected settingTone Control Settings Adjusting the Listening Modes—ContinuedPL IIx and Neo:6 Settings PL IIx Music 2 ch only Neo:6 MusicMono/Multiplex Settings Mono Dolby Digital SettingsLFE Level Setting MultiplexAdjusting the Listening Modes—Continued Default Listening ModesSETUP button When you’ve finished, press theSpeaker Setup Advanced SetupThe Speaker Setup menu appears Speaker ConfigurationLow-PassFilter for the LFE Channel Advanced Setup—ContinuedSubwoofer Mode Setup closesAdvanced Setup—Continued Speaker DistanceThe Speaker Setup menu appears Setup closesAdvanced Setup-Continued Speaker Level Calibrationlute volume setting 82. If you normally listen at The Speaker Setup menu appearsAdvanced Setup—Continued THX Audio SetupThe Speaker Setup menu appears 0–1ft 0–0.3m Default: Select thisAdvanced Setup—Continued Equalizer SettingsThe Speaker Setup menu appears The Equalizer Settings menu appearsCharacter Edit Input SetupAdvanced Setup-Continued To name an AM or FM radio presetVolume Setup IntelliVolumePreferences Advanced Setup—ContinuedHDMI Setup OSD SetupLock Setup OSD PositionRemote IDs Changing the Remote Controller’s IDChanging the AV Receiver’s Remote ID Advanced Setup—ContinuedAdvanced Setup—Continued Digital Input Signal FormatsSETUP button Press the SETUP buttonAdvanced Setup-Continued Correcting Sound and Picture SyncUsing an Amp in Zone Connecting ZoneUsing Only Speakers in Zone ZoneUsing Zone Powered Zone 2 SettingZone 2—Continued Controlling Zone 2 from the AV receiverAdjusting the Volume for Zone Controlling Zone 2 with the Remote ControllerZone 2—Continued To Mute ZoneUsing a Multiroom Kit with Zone Using a Multiroom Kit with a CabinetUsing a Multiroom Kit with Other Components Zone 2-ContinuedControlling Other Components Entering Remote Control Codesremote control code The Remote indicator flashes twiceResetting the REMOTE MODE Buttons Resetting the Remote ControllerControlling Other Components—Continued The Remote indicator flashes fiveCancels functions Cancels functionsAdjust the TV’s volume remote controller modethe Remote indicator flashes twice Learning Commands from Other Remote ControllersControlling Other Components—Continued Making Macros Using MacrosRunning Macros Deleting MacrosPower TroubleshootingAudio Video Troubleshooting—ContinuedTuner Remote ControllerRecording OthersTroubleshooting—Continued Amplifier Section SpecificationGeneral Video SectionONKYO U.S.A. CORPORATION 2 9 3 4 4 3ONKYO EUROPE ELECTRONICS GmbH ONKYO EUROPE UK Office
Top Page Image Contents