Planar SA2311W manual Connecting Cables, Steps

Page 11

Connecting Cables

To connect the monitor to your PC, please follow the steps as given below:

2

HDMI

DVI

VGA

 

 

 

 

1-1

1-2

1-3

 

 

VGA

DVI

HDMI

2 A

1-3 1-2 1-1

Steps

1.Connect one of the cables: VGA, DVI or HDMI.

Make sure both the monitor and computer are turned off.

1-1.Connect VGA Cable

Connect the blue VGA video cable to the computer. 1-2.Connect DVI Cable

Connect the white DVI cable to the computer. 1-3.Connect HDMI Cable

Connect the black HDMI cable to the computer.

2.Connect power cord

Connect the power cord to the monitor, then to a properly grounded AC outlet.

3.Turn on the monitor and computer

Turn on the monitor first, then turn on the computer. This sequence is very important.

4.If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.

Note: There is also a audio jack labeled “A” which allows you to connect the external headphone or speakers when the input source is HDMI.

9

Image 11
Contents 3D Ready Monitor Contents FCC Statement Warning PrefaceImportant Recycle Instruction Canadian DOC NoticeAbout Power Cable Safety PrecautionsCleaning Your Monitor Introduction InstallationFeatures Unpacking Preparing The Monitor For Wall-Mounting Page Figures below Screen Position AdjustmentSteps Connecting CablesSettings for Stereoscopic 3D Use Page Front Panel Controls Display ControlsOSD Lock Function Power Lock FunctionOSD OSD OperationInformation Content Technical Information SpecificationsMAC Supported TimingProblems Current Status Remedy TroubleshootingRegister Your Planar Products Today Product Registration and Technical Support020-1052-00 49.7J301.002