Planar SA2311W manual

Page 13

For the Quadro graphics cards, go to the nVidia Control Panel and enable stereo in the “Manage 3D Settings” tab.

When connecting the 3D Vision Ready monitor:

For boards with the stereo connector, select “On-board DIN connector (with NVIDIA IR Emitter)” and plug in the 3 pin mini-din to 1/8” stereo cable that came with your 3D Vision glasses kit.

For boards without the mini-din select “Generic Active Stereo (with NVIDIA IR Emitter).”

Note: Make sure the display refresh rate is set at 110Hz or 120Hz.

11

Image 13
Contents 3D Ready Monitor Contents FCC Statement Warning PrefaceImportant Recycle Instruction Canadian DOC NoticeCleaning Your Monitor Safety PrecautionsAbout Power Cable Features InstallationIntroduction Unpacking Preparing The Monitor For Wall-Mounting Page Figures below Screen Position AdjustmentSteps Connecting CablesSettings for Stereoscopic 3D Use Page Front Panel Controls Display ControlsOSD Lock Function Power Lock FunctionOSD OSD OperationInformation Content Technical Information SpecificationsMAC Supported TimingProblems Current Status Remedy TroubleshootingRegister Your Planar Products Today Product Registration and Technical Support020-1052-00 49.7J301.002