Planar SA2311W manual Preparing The Monitor For Wall-Mounting

Page 8

Preparing The Monitor For Wall-Mounting

1.Lay the LCD monitor on a flat surface with the LCD screen face down.

To prevent the monitor from being scratched, put a soft cloth on the table.

2.Use a screw driver to release the four screws from the stand pedestal as below.

3. Take the stand away from the monitor head.

4. Check the stability of the wall-mounting fixture.

6

Image 8

Contents 3D Ready Monitor Contents Preface FCC Statement WarningCanadian DOC Notice Important Recycle InstructionAbout Power Cable Safety PrecautionsCleaning Your Monitor Introduction InstallationFeatures Unpacking Preparing The Monitor For Wall-Mounting Page Screen Position Adjustment Figures belowConnecting Cables StepsSettings for Stereoscopic 3D Use Page Display Controls Front Panel ControlsPower Lock Function OSD Lock FunctionOSD Operation OSDInformation Content Specifications Technical InformationSupported Timing MACTroubleshooting Problems Current Status RemedyProduct Registration and Technical Support Register Your Planar Products Today020-1052-00 49.7J301.002