EN
ICON | DESCRIPTION | ||||
|
|
|
|
| Main unit is searching for |
|
|
|
|
| sensors. |
|
|
|
|
| |
|
|
|
|
| At least 1 channel has |
|
|
|
|
| been found. |
|
|
|
|
| |
|
|
|
|
| Channel 1 is selected |
|
|
|
|
| (number will change |
|
|
|
|
| depending on the sensor |
|
|
|
|
| you select) |
|
|
|
|
|
|
The selected sensor cannot | |||||
/ Humidity Areas | be found. Search for the | ||||
|
|
|
|
| sensor or check batteries. |
SEARCH FOR SENSOR
To search for a sensor, press and hold MEM and CHANNEL for 2 seconds.
NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location.
NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. This is normal and does not affect general product performance. The reception will resume once the interference ends.
8
CLOCK
This product can track the date and time for up to 2 locations (Clock with Offset Hour). The US Atomic Clock in Boulder, Colorado automatically updates this information unless you disable the feature. The signals are collected by the main unit when it is within 1500 km (932 miles) of a signal.
Initial reception takes 2 - 10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.
To force a manual search for Atomic Clock signals, press and hold UP for 2 seconds. If no signal is found, check the batteries.
NOTE If the Atomic Clock signal is received and the hour is incorrect, use the "hour offset" feature to adjust it to to the right value. Please see "SET CLOCK" on pg. 9 for instructions.
RMR613HGA lab test R2 | 8 | 1/17/04, 5:00 PM |