1.Insert the batteries, matching the polarity as shown in the battery compartment.
2.Set the channel. The switch is located in the battery compartment.
SWITCH | OPTION |
Channel | Channel 1 - 3. If you are using |
| more than one sensor, select a |
| different channel for each sensor. |
|
|
3.Place the sensor near the main unit. Press RESET on the sensor to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Search for Sensor section for more information.)
4.Close the remote sensor battery compartment.
5.Secure the sensor in the desired location using the wall mount or table stand.
7
For best results:
•Insert the batteries and select the channel and temperature unit before you mount the sensor.
•Place the sensor out of direct sunlight and moisture.
•Do not place the sensor more than 30 meters (98 feet) from the main (indoor) unit.
•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.
•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
•Position the sensor close to the main unit during cold winter months as
You may need to experiment with various locations to get the best results.
DATA TRANSMISSION
Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature and Humidity Areas show the status.
EN
RMR613HGA lab test R2 | 7 | 1/17/04, 5:00 PM |