EN
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need to purchase 2 x
CHANGE SETTINGS
1.Press and hold MODE for 2 seconds to enter setting mode.
2.Press UP or DOWN to change settings.
3.Press MODE to confirm.
Insert the batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.
NOTE Do not use rechargeable batteries.
shows when batteries are low.
UNIT | LOCATION |
Main | Temperature Area when |
| the INDOOR temperature |
| is shown. |
|
|
Remote | TemperatureArea when the |
| OUTDOOR temperature is |
| shown. |
|
|
6
REMOTE SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/ Hygro Sensor that collects Temperature and Humidity data. Data can be collected from up to 3 sensors. Additional sensors sold separately.
SETUP SENSOR
Open the remote sensor battery compartment with a small Phillips screwdriver.
RMR613HGA lab test R2 | 6 | 1/17/04, 5:00 PM |