Mitsumi electronic XD206U user manual Menu operation

Menu operation (continued)
1 IMAGE
CONTRAST	Use to adjust the image contrast. The contrast becomes		opt.
	higher as the value increases.			XGA60
BRIGHTNESS	Use to adjust the image brightness. The image becomes	IMAGE
	brighter as the value increases.		CONTRAST	0
WHITE ENHANCE	Use to adjust the white level of the projected image.
			BRIGHTNESS	0
COLOR TEMP	Use to adjust the color temperature. See page 18.
			WHITE ENHANCE	10
COLOR	Use to adjust the color intensity of the image.
			COLOR TEMP.	STANDARD
TINT	Use to adjust the color balance of the image. The color
			COLOR	0
	balance shifts to green as the value increases and shifts
			TINT	0
	to purple as the value decreases. (Available only when
	VIDEO or S-VIDEO is chosen as the source.)		SHARPNESS	0
	• When the TV50 (PAL, SECAM) signal is input, TINT		GAMMA MODE	STANDARD
	can’t be adjusted.
SHARPNESS	Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not available
	with certain signals.)
GAMMA MODE	When AUTO is selected, the appropriate gamma mode is automatically selected depending on the
	input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select STAN-
	DARD for sport scenes and video sources. Select THEATER for film sources.
2 INSTALLATION
AUTO POWER ON	When ON is chosen, the lamp is automatically lit when		opt.
	the power cord is plugged in the wall outlet. Choose ON			XGA60
	when using the projector mounted on the ceiling.	INSTALLATION
	• The projector is in the stand-by mode when the lamp		AUTO POWER ON	OFF
	is off. Use the remote control to turn on the lamp.
			AUTO POWER OFF	OFF
AUTO POWER OFF	Use to set the time elapsed before the projector enters
		ON
			SPLASH SCREEN	ON
	the stand-by mode when there is no signal input from the
			BACK COLOR	BLUE
	source.
			LAMP MODE	STANDARD
SPLASH SCREEN	Choose ON to display the splash screen when the power
	is turned on.		IMAGE REVERSE	OFF
BACK COLOR	Use to select the background from among BLUE and		LAMP HOURS	0
	BLACK, which will be displayed when there is no signal
	input from the source.
LAMP MODE	Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low and
	the projector operating noise is reduced, resulting in a longer lamp replacement interval.

	• When the lamp mode is switched, the projected image may flicker. This is not a product malfunc-
	tion.
	• Do not change the setting of LAMP MODE frequently.
	• When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
	about one minute after turn on.
IMAGE REVERSE	Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-mounted
	projector. Select MIRROR INVERT for front projection with the ceiling-mounted projector.
LAMP HOURS	The duration of illumination of a lamp converted in the Low mode is displayed.

EN-16