Optoma Technology TH7500NL manual Regulation & Safety Notices, FCC notice

Page 69

Appendices

Regulation & Safety Notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

69English

Image 69
Contents Table of Contents Usage Notice Safety InformationPrecautions Do not Product Features Eye Safety WarningsPackage Overview IntroductionMain Unit Product OverviewControl Panel Input/Output Connections Remote Control Install the Projection Lens Connecting the ProjectorConnect to Computer/Notebook Connect to Video Sources Powering On the Projector Powering the projector On / OffPowering off the projector See pages For more information Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting the Projector’s Position Lens User Controls Control Panel & Remote ControlUsing the Remote Control Hdmi On-screen Display Menus How to operateImage Menu TreeSetup Display Mode BrightnessContrast Sharpness ColorTint Image Advanced Color Settings Color SpaceInput Source Format DisplayEdge Mask Zoom Digital ZoomImage Shift KeystoneAuto Keystone PIP Location ScreenPIP Size PIP SourceProjection LanguageScreen Type Menu LocationProjector ID Lens Function Security Timer Setup SecurityChange Password SecurityUser Controls Phase Setup Signal RGBFrequency PositionWhite Level Setup Signal VideoBlack Level SaturationLogo Setup AdvancedLogo Capture Closed CaptioningSetup Network How to use web browser to control your projector Click Change settings of this connection High Altitude Source LockInformation Hide Keypad LockVGA Out ResetFunction Option Remote SettingsIR Function Remote CodeUser Controls Option Advanced Lamp Settings Brightness Mode InformationInformation Appendices TroubleshootingImage is unstable or flickering Image is reversed Projector stops responding to all controls On Screen Messages Replacing the lamp Lamp Replacement Procedure  Computer Compatibility PC Compatibility Modes Video Compatibility Mode Resolution Sync Hz Sync KHz Analog Digital Computer Compatibility MAC RS232 Pin Assignments RS232 Commands and Protocol Function ListSend to projector RS232 Protocol Function ListIRE Send from projector automatically Ceiling Mount Installation USA Optoma Global OfficesLatin America FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs canadiens