Appendices
The image is stretched when displaying 16:9 DVD title
When you play anamorphic DVD or 16:9 DVD, the projector will show the best image in 16:9 format in OSD. If you play 4:3 format DVD title, please change the format as 4:3 in projector OSD. If the image is still stretched, you will also need to adjust the aspect ratio by referring to the following:
4Please setup the display format as 16:9 (wide) aspect ratio type on your DVD player.
Image is too small or too large
4Adjust the Zoom Ring on the top of the projector.
4Move the projector closer to or further from the screen.
4Press Menu button on the remote control or projector panel, go to Display Format and try the different settings.
Image has slanted sides
4If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen.
4Press Keystone +/- on the remote control until the sides are vertical.
Image is reversed
4Select Setup Projection from the OSD and adjust the projection direction.
Intermission Problems
The projector stops responding to all controls
4If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
4When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in Replacing the Lamp on page 81.
77English