Installation
vTurn on the projector first and then select the signal sources.
Powering On/Off the Projector
Powering On the Projector
1.Remove the lens cover.
2.Connect the power cord to the projector.
3.Turn On the connected devices.
4.Ensure the Power LED turns red and then press the power button to turn On the projector.
The Power LED will now flash blue.
The startup screen will display in approximately 30 seconds. The first time you use the projector, you can select your preferred language and Power Mode setup after the startup screen display.
If the connected device is a PC, ensure the display is set to output to the projector via the connected output. (Check the user manual of the PC to determine the appropriate Fn key combination to change display output.)
English 18